Results 71 to 80 of about 5,600,786 (304)
Advances in Materials Science and Engineering, 2020 This study investigates the distribution of pore water on the basis of the measured mass moisture content after soaking the tunnel insulation material. This study also analyzes the influence of the distribution of pore water on the thermal conductivity ...
Youyun Li +4 more
doaj +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
On-line moisture measurement of rocks, using microwave techniques
, 1989 Includes bibliographical references.On-line measurement of the moisture content of process streams in a mineral processing plant is vital for their efficient operation.
Celliers, Scarre
core
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
NON-LINEAR PARAMETER ESTIMATION OF EMC/ERH CORRELATIONS FOR GRAIN-TYPE PRODUCTS [PDF]
, 2000 A mathematical prediction of corn sorption isotherm was developed for three-parameter EMC correlation such as Modified-Henderson, Modified-Chung-Pfost, Modified-Oswin, and Modified-Halsey.
Istadi, I. +2 more
core
Evaluation of European Land Data Assimilation System (ELDAS) products using in site observations
, 2008 Three land-surface models with land-data assimilation scheme (DA) were evaluated for one growing season using in situ observations obtained across Europe. To avoid drifts in the land-surface state in the models, soil moisture corrections are derived from
Viterbo, P. +10 more
core +1 more source
Thermo-mechanical processing of sugar beet pulp. II. Thermal and rheological properties of thermoplastic SBP [PDF]
, 2006 Thermoplastic properties of extruded sugar beet pulp (SBP) are closely linked to water–polymer relationships. DSC analyses of water evaporation, water fusion and biopolymer relaxation according to SBP moisture content gave a more accurate estimation of ...
Rouilly, Antoine +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Design of methodology for wood chips moisture estimation determined for gasification
EPJ Web of Conferences, 2014 The moisture content of the charged wood chips is a significant factor affecting the gasification process. The increased moisture content increases the demand on the energy consumption, which is needed to cover the heat consumption related to the water ...
Lukáč Ladislav +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source