Condensation Targeter II: modelling surface relative humidity to predict mould growth in dwellings [PDF]
, 1999 Condensation and mould growth are reported as being problems in an estimated 4.2 million dwellings in England, resulting in poor health for the occupants and substantial damage to the fabric of the building.
Oreszczyn, T. +3 more
core +1 more source
Evaluation of the Effect of External Conditions During Crystallization and Solidification on the Final Structure of AlSi7Mg [PDF]
Archives of Foundry Engineering, 2023 The paper deals with the possibilities of influencing the final microstructure of aluminium alloy castings by changing the external conditions of crystallization and solidification.
F. Radkovský +2 more
doaj +1 more source
Damp and Mould: Chair’s Introduction and Overview [PDF]
Overview and update of damp and mould in social ...
Stewart, Jill
core +5 more sources
Effect of Input Parameters on The Mechanical Properties of Green Sand Mould [PDF]
Archives of Foundry EngineeringAmong all the methods of metal forming, green sand moulding is the most commonly used method due to its low cost and high speed of work. Main constituents of green sand mould are sand, water, coal dust and binder. Mechanical properties like permeability,
Arpit H. Modi, Shailee G. Acharya
doaj +1 more source
Hardness determination of bio-ceramics using laser-induced breakdown spectroscopy. [PDF]
, 2011 Laser-Induced Breakdown Spectroscopy (LIBS) was applied to the analysis of bioceramic samples. The relationship between sample hardness and LIBS plasma properties was investigated, with comparison to conventional Vickers hardness measurements.
Moser, D. +23 more
core +1 more source
A new method for hardness determination from depth sensing indentation tests [PDF]
, 1996 A new semiempirical formula is developed for the hardness determination of the materials from depth sensing indentation tests. The indentation works measured both during loading and unloading periods are used in the evaluation.
Juhász, A. +2 more
core +1 more source
Interchangeable core and cavity plates for two-plate family injection mould
Journal of Mechanical Engineering and Sciences, 2017 This study modified a two-plate family plastic injection mould to become interchangeable by changing the core and cavity plates using an existing mould base.
M. A. M. Ali +6 more
doaj +1 more source
Hardness Evaluation of Porous Hydroxyapatite Coating [PDF]
, 2007 The extensive use of appropriate coatings to improve wear resistance, friction coefficient, electrical properties, corrosion resistance and biomedical application has stimulated a growing interest in their mechanical properties and especially hardness ...
A. Iost +7 more
core +1 more source
Mould and winter indoor relative humidity in low income households in England [PDF]
, 2006 This paper examines the extent to which variation in heating-season, indoor relative humidity (RH) and mould occurrence in English households is explained by dwelling and household characteristics. It is based on analysis of data from a national study of
Tadj Oreszczyn +13 more
core +1 more source
Microstructures and mechanical properties of Ni60 alloy fabricated by laser metal deposition
Materials Research Express, 2020 Due to its low melting point and high hardness, Ni60 (Ni–Cr–B–Si) alloy is widely used as surface cladding material for mould steel. In present study, Ni60 alloy thin-walled samples were fabricated using laser metal deposition (LMD) technology on H13 ...
Wenquan Wang +5 more
doaj +1 more source