Results 1 to 10 of about 7,888 (250)
Direct Observation of Matrix‐to‐Precipitate Elemental Diffusion in Severe Plastic Deformation
Rare Metals, Volume 45, Issue 4, April 2026.ABSTRACT Elemental redistribution, particularly the solute exchange between the matrix and precipitates, is a central issue in alloys subjected to severe plastic deformation (SPD). To elucidate this behavior, a nickel–aluminum bronze (NAB) alloy was processed by high‐pressure torsion (HPT), and its microstructural evolution was systematically ...
Xiaobin Yang +9 more
wiley +1 more source
Surface Characteristics and Fatigue Behavior of Gradient Nano-Structured Magnesium Alloy
Metals, 2017 High-frequency impacting and rolling was applied on AZ31B magnesium alloy to obtain a gradient nano-structured surface. Surface characteristics were experimentally investigated, and the nanocrystallization mechanism is discussed in detail. Results showed
Xiaohui Zhao, Yanjun Zhang, Yu Liu
doaj +1 more source
Joule heating as a technique for obtaining uncoupled soft and hard magnetic phases in a Finemet alloy [PDF]
, 2007 A detailed study on the microstructural evolution of the Fe73.9Cu0.9Nb3.1Si13.2B8.9 Finemet alloy upon Joule heating and its correlation with the magnetic properties is reported.
Conde Amiano, Alejandro +3 more
core +1 more source
Revealing the Cluster‐Cloud and Its Role in Nanocrystallization
Advances in Materials, 2019 Elucidating the early stages of crystallization from supersaturated solutions is of critical importance, but remains a great challenge. An in situ liquid cell transmission electron microscopy study reveals an intermediate state of condensed atomic ...
Biao Jin +6 more
semanticscholar +1 more source
Rare Metals, Volume 45, Issue 4, April 2026.ABSTRACT The inherent trade‐off between high saturation induction (Bs) and low core loss in soft magnetic materials presents a challenge in the development of high‐frequency power electronics. Here, a processing approach that combines accelerated Cu ordering with dual magnetic anisotropy control in high‐Bs Fe‐based nanostructured cores is examined ...
Xiaoying Li +11 more
wiley +1 more source
Magnetic and structural properties of nanocrystalline PrCo$_3$
, 2011 The structure and magnetic properties of nanocrystalline PrCo$_3$ obtained from high energy milling technique are investigated by X-ray diffraction, Curie temperature determination and magnetic properties measurements are reported.
J C Crivello +4 more
core +2 more sources
Magnetocaloric effect in Mn-containing Hitperm-type alloys. [PDF]
, 2007 The magnetocaloric effect of Fe60−xMnxCo18Nb6B16 x=0,2,4 is studied. Mn addition decreases the Curie temperature of the alloys but also reduces the peak entropy change and the refrigerant capacity of the material.
Blázquez Gámez, Javier Sebastián +4 more
core +1 more source
Advanced Physics Research, Volume 5, Issue 3, March 2026.Cd2SnO4 exhibits excellent thermoelectric properties with a high Seebeck coefficient, power factor, and figure of merit, surpassing Bi2Te3. It shows both positive and negative Seebeck coefficient values, making it suitable for diverse applications. Its high electrical conductivity and low thermal conductivity enhance efficiency, while its negative Hall
Adel Bandar Alruqi, Nicholas O. Ongwen
wiley +1 more source
Materials & Design (1980-2015), 2018 In this study, gradient nanocrystallization and enhanced surface mechanical properties in commercial pure titanium, which were induced by an electropulsing-assisted ultrasonic surface rolling process (EP-USRP), were systematically investigated.
Y. Ye +5 more
semanticscholar +1 more source
Journal of the American Ceramic Society, Volume 109, Issue 3, March 2026.ABSTRACT Mechanoluminescence, defined as the non‐thermal emission of light in response to mechanical stimulation, has garnered significant attention over the past two decades, with research predominantly centered on enhancing the emission intensity of active phosphors.
Meiyu Yang +4 more
wiley +1 more source