Results 31 to 40 of about 503,570 (301)
Journal of Asian Ceramic Societies, 2020 The aim of this research is the evaluation of the influence of TiN, CrN and TiN/CrN nanostructured coatings on corrosion resistance of nickel-chromium dental alloy in artificial saliva environment with two pH levels (3.0 and 6.5).
Nidhal Sahib Mansoor +3 more
doaj +1 more source
Oxidation resistance of the nanostructured YSZ coating on the IN-738 superalloy [PDF]
Journal of Ultrafine Grained and Nanostructured Materials, 2014 Conventional and nanostructured YSZ coatings were deposited on the IN-738 Ni super alloy by the atmospheric plasma spray technique. The oxidation was measured at 1100°C in an atmospheric electrical furnace.
Ahmad Keyvani +2 more
doaj +1 more source
Nanostructured high-strength alloys [PDF]
Science, 2017 Metallurgy Low-density magnesium alloys are a promising type of material for making lighter vehicles and improving fuel efficiency. One challenge for lightweighting is developing high-strength magnesium alloys. Wu et al. created a dual-phase magnesium thin film with near-ideal strength.
openaire +2 more sources
APL Materials, 2016 Thermoelectric properties of nanostructured FeSi2, Mg2Si, and SiGe are compared with their nanocomposites of SiGe–Mg2Si and SiGe–FeSi2. It was found that the addition of silicide nanoinclusions to SiGe alloy maintained or increased the power factor while
Amin Nozariasbmarz +7 more
doaj +1 more source
TEM investigation on microstructural characteristics in nanostructured Al-Mg alloy
, 2003 The microstructural evolution in a nanostructured Al-Mg alloy fabricated by cryogenic mechanical alloying (cryomilling), was investigated using transmission electron microscopy (TEM).
Chung, K.H +7 more
core +2 more sources
Microstructure and Properties of TiC/Ti Coatings Deposited by the Supersonic Cold Gas Spray Technique [PDF]
Archives of Metallurgy and Materials, 2018 Nanostructured, biocompatible, TiC/Ti Supersonic Cold Gas Sprayed coatings were deposited onto a Ti6Al4V alloy and their microstructure, wear resistance and hardness were investigated. The starting nanostructured powder, containing a varied mixture of Ti
J. Kusiński +6 more
doaj +1 more source
High-Speed Erosion Behavior of Hydrophobic Micro/Nanostructured Titanium Surfaces
Nanomaterials, 2022 Ice accretion on aircrafts or their engines can cause serious problems and even accidents. Traditional anti-icing and de-icing systems reduce engine efficiency, which can be improved by the use of hydrophobic/icephobic coatings or surfaces that reduce ...
Yong Chen, Jiguo Zhang
doaj +1 more source
Nanostructured biodegradable Zn-Mn for biomedical application.png
, 2020 Characterization of nanostructured biodegradable Zn-Mn alloy .....” for Implant ...
Mehrdad Khakbiz (8733549)
core +1 more source
Nanostructured Ni-Fe-S Based Electrode for Hydrogen Production by Water Electrolysis
Chemical Engineering Transactions, 2023 Green hydrogen is a real alternative to change the current energy system. Electrochemical water splitting is considered an attractive solution to convert and store the surplus of renewable energy sources.
Bernardo Patella +8 more
doaj +1 more source
Hardening nanostructures in an AlZnMg alloy [PDF]
Philosophical Magazine, 2007 The formation of nanoscale and sub-nanoscale solute aggregates (clusters, Guinier–Preston zones and precipitates) in an AlZnMg alloy (Al–2.1 at.% Zn–1.5 at.% Mg) has been followed by a combination of experimental techniques with the aim of correlating the properties of the aggregates with their thermal history.
DUPASQUIER, ALFREDO +8 more
openaire +1 more source