Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
BioengineeringAnaerobic ammonium oxidation (anammox) technologies have attracted substantial interest due to their advantages over traditional biological nitrogen removal processes, including high efficiency and low energy demand.
Pradeep Singh +8 more
doaj +1 more source
Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC
Advanced Engineering Materials, EarlyView.ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko +2 more
wiley +1 more source
Ion Exchange for Nutrient Recovery Coupled with Biosolids-Derived Biochar Pretreatment to Remove Micropollutants [PDF]
, 2018 Wastewater, especially anaerobic treatment effluent, contains high ammonia nitrogen (NH4-N) and inorganic orthophosphate (PO4-P), which necessitate additional treatment to meet stringent discharge regulations.
Avila, Anna +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.Fungal mycelia grown into biodegradable scaffolds and infused with titania nanoparticles show enhanced ultraviolet shielding, thermal protection, and surface nonwettability. Properties were tuned by drying methods, revealing structure–function relationships.
Juwon S. Afolayan +2 more
wiley +1 more source
Provisions for nonintrusive flow-evaluation tools in the National Transonic Facility [PDF]
The national transonic facility fan driven, closed circuit, continuous flow, pressurized wind tunnel is examined. The test section is 2.500 m x 2.500 m and 7.620 m long with a slotted wall configuration.
Fuller, D. E.
core +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Assessment of Effectiveness of Buffer Zones in Removing Impurities in Runoff from Areas Treated with Poultry Litter. Part II: Source Areas to Buffer Areas Ratio Effects [PDF]
, 1995 Vegetative filter strips (VFS) are known to reduce runoff losses of nutrients. solids. and other materials from land areas treated with fertilizers . Although VFS effectiveness is known to depend partially on the relative lengths of filter and pollutant ...
Daniel, T. C. +2 more
core +2 more sources
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Quantitative Assessment of Oysters’ Multiple Nitrogen Removal Pathways in a Subtropical Bay
Journal of Marine Science and EngineeringOyster aquaculture helps mitigate coastal eutrophication by assimilating organic nitrogen for biomass and by denitrification in both the oyster digestive tract and sediment below.
Rongxin Liu +3 more
doaj +1 more source