Results 71 to 80 of about 391,550 (319)

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Efficient Pulsed Raman Laser with Wavelength above 2.1 μm Pumped by Noise‐Like Pulse

open access: yesAdvanced Photonics Research
Herein, the efficiently high‐power pulsed Raman lasers with wavelength above 2.1 μm are experimentally demonstrated relying on the stimulated Raman scattering.
Meng Wang   +7 more
doaj   +1 more source

Dual-Operation Regime Thulium-Doped Fiber Laser and Its Applications in Cascaded Raman Light and Supercontinuum Generation

open access: yesIEEE Photonics Journal, 2018
We report on a passively mode-locked thulium-doped fiber laser (TDFL) with dual operation regimes and applications in cascaded Raman light and supercontinuum generation.
Zhijian Zheng   +6 more
doaj   +1 more source

Chimera states in pulse coupled neural networks: the influence of dilution and noise [PDF]

open access: yes, 2016
We analyse the possible dynamical states emerging for two symmetrically pulse coupled populations of leaky integrate-and-fire neurons. In particular, we observe broken symmetry states in this set-up: namely, breathing chimeras, where one population is ...
Olmi, Simona, Torcini, Alessandro
core   +3 more sources

In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal   +4 more
wiley   +1 more source

Trigonometric functions-based gaussian-like shaping algorithms for nuclear signals

open access: yesHe jishu
BackgroundGaussian shaping is commonly used to filter and extract the amplitude of nuclear pulse signals owing to its high signal-to-noise ratio, resistance to ballistic loss, and ease of amplitude extraction.
QIAN Yunchen   +5 more
doaj   +1 more source

Investigating the Capabilities of Ensemble Machine Learning Model in Identifying Near-Fault Pulse-Like Ground Motions [PDF]

open access: yesJournal of Soft Computing in Civil Engineering
In recent years, the detection and analysis of near-fault pulse-like ground motions have become increasingly crucial due to their potential to cause significant structural damage during seismic events.
Jafar Al Thawabteh   +3 more
doaj   +1 more source

Noise spectra of stochastic pulse sequences: application to large scale magnetization flips in the finite size 2D Ising model

open access: yes, 2008
We provide a general scheme to predict and derive the contribution to the noise spectrum of a stochastic sequence of pulses from the distribution of pulse parameters.
Clare C. Yu, K. Huang, Zhi Chen
core   +2 more sources

An Experimental High‐Throughput Approach for the Screening of Hard Magnet Materials

open access: yesAdvanced Engineering Materials, EarlyView.
An entire workflow for the high‐throughput characterization and analysis of compositionally graded magnetic films is presented. Characterization protocols, data management tools and data analysis approaches are illustrated with test case Sm(Fe, V)12 based films.
William Rigaut   +16 more
wiley   +1 more source

Printed Integrated Logic Circuits Based on Chitosan‐Gated Organic Transistors for Future Edible Systems

open access: yesAdvanced Functional Materials, EarlyView.
Edible electronics needs integrated logic circuits for computation and control. This work presents a potentially edible printed chitosan‐gated transistor with a design optimized for integration in circuits. Its implementation in integrated logic gates and circuits operating at low voltage (0.7 V) is demonstrated, as well as the compatibility with an ...
Giulia Coco   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy