Results 231 to 240 of about 1,842,183 (305)

Effect of Oxygen Content on Surface and Subsurface Integrity During Turning of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
This study examines how oxygen content in the ambient atmosphere affects the surface and subsurface properties of Ti–6Al–4V during turning. Results show that oxygen does not influence surface roughness. However, machining in an extremely high vacuum‐adequate atmosphere increases surface hardness by up to 7.8% and induces compressive residual stresses ...
Benjamin Bergmann, Berend Denkena, Hilke Petersen, Florian Schaper   +3 more
wiley   +1 more source

Non-contact optical spectroscopy for metabolic and vascular characterizations of orthotopic tongue cancer models <i>in vivo</i>. [PDF]

IEEE J Sel Top Quantum Electron
Hasan MZ, Yan J, Sarker S, Saha PS, Zhu C.   +4 more
europepmc   +1 more source

Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere

Advanced Engineering Materials, EarlyView.
A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz, Maik Szafarska, René Gustus, Kai Möhwald, Hans Jürgen Maier   +4 more
wiley   +1 more source

Non-contact detection of post-regurgitation deep inhalation in calves using infrared thermography and deep learning-based nostril segmentation. [PDF]

BMC Vet Res
Kim S, Yamagishi N, Ishikawa S, Tsuchiaka S.   +3 more
europepmc   +1 more source

Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition

Advanced Engineering Materials, EarlyView.
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley   +1 more source

Dynamic Vision-Based Non-Contact Rotating Machine Fault Diagnosis with EViT. [PDF]

Sensors (Basel)
Jin Z, Sun C, Li X.
europepmc   +1 more source

On the Influence of Antioxidants and Recycled MgO–C Source Material on the Mechanical Properties of Carbon‐Bonded Magnesia Refractories

Advanced Engineering Materials, EarlyView.
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann, Tom Weber, Jana Hubálková, Florian Kerber, Dinesh Kumar Gunasekar, Hans Jelitto, Christos G. Aneziris   +6 more
wiley   +1 more source

Design and Simulation Test of Non-Contact Voltage Sensor. [PDF]

Sensors (Basel)
Peng H, Liu H, Shang K, Li G, Zhao L.
europepmc   +1 more source

Assessment of Intraocular Pressure Measurement Between Goldmann Applanation Tonometer and Portable Non-Contact Tonometer (TH1U). [PDF]

Clin Ophthalmol
Peng X, Wang J, Chen J, Wu Y, Wang T, Li W, Xu X.   +6 more
europepmc   +1 more source

Non-contact imaging of the neck for monitoring cardiopulmonary clinic patients. [PDF]

Biomed Opt Express
Farahani MHD, Bolic M, Zhang T, Zadorsky T, Sabbagh R.   +4 more
europepmc   +1 more source