Results 201 to 210 of about 32,552 (250)
Generalized EIS Measurement Method in Li-Ion Batteries. [PDF]
Sensors (Basel)Nogales JM +4 more
europepmc +1 more source
Digital OTAs: Conventional Designs Versus Emerging Concept
Akbari M, Covi E, Gibertini P.
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
On the Definition of Reactive Power Under Non-Sinusoidal Conditions
IEEE Transactions on Power Apparatus and Systems / Technical Operations Committee, 1980A new method of defining reactive power under non- sinusoidal conditions is proposed. It consists of sub- dividing the current into components which would have the same waveform as the current in a resistance and either an inductance or a capacitance when the voltage is applied to them, and into a residual component.
Kusters, N. L., Moore, W. J.M.
exaly +3 more sources
Power meter verification issue: Reactive power measurement in non sinusoidal conditions
2015 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Proceedings, 2015In this paper, the authors propose a methodology to guide verification of single phase reactive power meters under non sinusoidal conditions. At first, it is presented a brief review about different definitions of reactive power proposed in literature. Then a test signal for the detection of the implemented approach without a priori knowledge provided ...
Daniele Gallo, C Landi, Mario Luiso
exaly +3 more sources
Modelling of Power Components in Non-Sinusoidal Power Systems Using Hilbert Transform
International Journal of Modelling and Simulation, 2005AbstractThis article presents a Hilbert transform-based approach of power components definition in non-sinusoidal power systems. Instantaneous phasors of current and voltage, apparent power, and power factor are also defined. The proposed Hilbert transform-based method is applicable to sinusoidal or non-sinusoidal, single-phase systems as well as ...
exaly +2 more sources
The Method of Power Factor Calculation under Non-Sinusoidal Conditions
2020 IEEE Conference of Russian Young Researchers in Electrical and Electronic Engineering (EIConRus), 2020The method of power factor calculation under non-sinusoidal conditions is presented in the paper. The proposed method is based on the existing relationships between the components of apparent power under non-sinusoidal conditions. The equation for determination of total power factor under non-sinusoidal conditions is obtained and proved.
Yuriy A Sychev, Boris N Abramovich
exaly +2 more sources
Experimental Study of Power Definitions in Non-sinusoidal Condition
2022 5th International Conference on Electronics and Electrical Engineering Technology (EEET), 2022Mohammad Abu Sarhan +2 more
exaly +2 more sources
Determination of Apparent Power Components in Non-Sinusoidal Circuits
2006 Large Engineering Systems Conference on Power Engineering, 2006This paper presents a Hilbert-transform (HT) based approach to determine apparent power components in non-sinusoidal circuits with zero instantaneous power. Instantaneous current and voltage phasors, instantaneous active power, instantaneous reactive power, and instantaneous apparent power are also, defined.
exaly +2 more sources
Parametric approach for power measurements under non‐sinusoidal conditions
European Transactions on Electrical Power, 1994AbstractThe determination of the power components under non‐sinusoidal conditions has received great attention in the last years. Digital instrumentation, provided of signal processing capability, allows to accomplish this task by evaluating the voltage and current spectral characteristics, from which all the needed power components can be derived. The
C. Offelli, Petri, Dario, F. Zanin
openaire +2 more sources