Results 131 to 140 of about 372,244 (310)
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Regularities of uranium distribution in groundwater of ChNPP industrial site
Ядерна фізика та енергетика, 2017 Observed significant increase of migration properties of uranium from groundwater happens when pH rises above 9 - 10 against significant increases in the concentrations of major ions: Na+, K+, СО32-, NO2-, NO3-.
M. I. Panasyuk, I. A. Lytvyn
doaj
Biological dosimetry dose-response curves for residents living near nuclear power plants in South Korea. [PDF]
Sci Prog, 2023 Jeong SK +11 more
europepmc +1 more source
The system of active gas purification of Beloyarskaya nuclear power plant unit BN-800 [PDF]
, 2017 The primary circuit gas treatment system of nuclear power plants are one of the most important systems that affect reliable, economical and safe operation of nuclear power plants.
Bibik, I. S. +3 more
core
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
An open time-series simulated dataset covering various accidents for nuclear power plants. [PDF]
Sci Data, 2022 Qi B +5 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
Hungarian Fine-to-Coarse Aggregate, a Possible Constituent of Near-Vessel Structural Concrete of Nuclear Power Plants. [PDF]
Materials (Basel), 2023 Gméling K +3 more
europepmc +1 more source
Measurement of residual stresses in a dissimilar metal welded pipe [PDF]
, 2011 Dissimilar metal welds (DMW) are used in light water reactor power plants to join ferritic and austenitic steel piping components. High residual stresses remaining in this type of welded joint can significantly increase its susceptibility to stress ...
Bouchard, John +4 more
core