Results 151 to 160 of about 801 (212)
Enhanced Electrochemical Oxidation of Ethanol Over Nickel Foam Supported Pt–Au Alloy Electrode
ChemElectroChem, Volume 13, Issue 12, 17 June 2026.Nickel foam‐supported strategically engineered Pt–Au alloy with a Pt‐enriched surface and Au‐rich bulk promotes strong electronic and bifunctional synergies. This structural design drives highly efficient ethanol electro‐oxidation, proceeding through an acetaldehyde intermediate to produce acetate.
Xing Tan +4 more
wiley +1 more source
Dynamic Oxygen Species Evolution Boosts Acidic Water Oxidation on W‐Doped RuO2
ChemElectroChem, Volume 13, Issue 12, 17 June 2026.Dynamic oxygen species evolution is triggered in tungsten‐doped RuO2 through regulated lattice oxygen diffusion kinetics during acidic oxygen evolution. An optimized oxygen diffusion coefficient balances lattice oxygen participation and vacancy replenishment, driving the transformation from defective low‐coordination sites into a stable six‐coordinated
Bichen Yuan +8 more
wiley +1 more source
An overview of core OCP requirements
This report contains core OCP requirements as defined through analysis of the working domain. These requirements cover a technical/architectural point of view, but also include a working process and institutional perspective. The requirements will be described using the MoSCOW typology (must-have, should-have, could-have, would-have).
openaire +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
SAE Technical Paper Series, 2001
<div class="htmlview paragraph">Outokumpu Copper Strip AB has developed Copper alloys for use in heat exchanger applications where high temperature joining is employed. The alloys are basically low alloyed Copper and Brass. These alloys are particularly suitable for the brazing of Copper and Brass heat exchangers.
Anders Falkenö, Markku Ainali
openaire +1 more source
<div class="htmlview paragraph">Outokumpu Copper Strip AB has developed Copper alloys for use in heat exchanger applications where high temperature joining is employed. The alloys are basically low alloyed Copper and Brass. These alloys are particularly suitable for the brazing of Copper and Brass heat exchangers.
Anders Falkenö, Markku Ainali
openaire +1 more source
Science of The Total Environment, 2016
Passive air samplers (PAS) were deployed concurrently at 15 locations (nine urban sites and six rural sites) in Vietnam and exposed for approximately 6 weeks from June 26, 2012 to August 26, 2012 and from December 8, 2012 to February 8, 2013. The concentration, composition and enantiomeric signatures of the target compound and Air Mass Backward ...
Weitao, Wang +8 more
openaire +2 more sources
Passive air samplers (PAS) were deployed concurrently at 15 locations (nine urban sites and six rural sites) in Vietnam and exposed for approximately 6 weeks from June 26, 2012 to August 26, 2012 and from December 8, 2012 to February 8, 2013. The concentration, composition and enantiomeric signatures of the target compound and Air Mass Backward ...
Weitao, Wang +8 more
openaire +2 more sources
Dynamic Verification of OCP-based SoC
2005 International Symposium on System-on-Chip, 2005Open core protocol (OCP) is a high configurable protocol set and it is a standard for on-chip interconnects widely used in wireless and multimedia applications. The paper describes the authors' experience in verification of open-core protocol based SoC with the use of an e-verification component (eVC), both at module and system level.
Natale Barsotti +3 more
openaire +1 more source
Contraception, 2010
This letter to the editor focuses on the growing body of evidence exonerating obesity as a risk factor for hormonal contraceptive failure. Copyright © 2010 Elsevier Inc. All rights reserved.
openaire +1 more source
This letter to the editor focuses on the growing body of evidence exonerating obesity as a risk factor for hormonal contraceptive failure. Copyright © 2010 Elsevier Inc. All rights reserved.
openaire +1 more source