Results 21 to 30 of about 757,728 (303)
AC Microgrids Protection: A Digital Coordinated Adaptive Scheme
Applied Sciences, 2021 A significant challenge for designing a coordinated and effective protection architecture of a microgrid (MG) is the aim of an efficient, reliable, and fast protection scheme for both the grid-connected and islanded modes of operation.
Noor Hussain +6 more
doaj +1 more source
Design of protection module of intrinsic safety power supply based on LT4356
Gong-kuang zidonghua, 2014 In view of problems of simple protection function, low conversion efficiency, poor anti-interference ability and low intrinsic safety current existed in current protection module of intrinsic safety power supply, a protection module of intrinsic safety ...
XIE Guojun +3 more
doaj +1 more source
Energy Reports, 2022 Under the development trend of AC/DC hybrid power grids, converter transformers are indispensable as AC/DC conversion equipment, whose safety and stability are particularly important.
Yuanlin Pan +5 more
doaj +1 more source
Design analysis of mine-used intrinsic safety power supply
Gong-kuang zidonghua, 2014 In view of requirements that intrinsic safety power supply must has multi-protection of over-current and over-voltage, the paper introduced working principle of a circuit of mine-used intrinsic safety power supply based on LM317 regulator, analyzed ...
LIU Qi
doaj +1 more source
A novel chopping current protection circuit for intrinsically safe power supply
Gong-kuang zidonghua, 2016 For problems that traditional chopping current protection circuit had small cut-off current value and poor anti load impact ability, and needed additional recovery circuit or manual circuit after over-current fault, a novel chopping current protection ...
FANG Xupeng +4 more
doaj +1 more source
Heliyon, 2021 Protection coordination of AC microgrids (MGs) is a challenging task since they can operate either in grid-connected or islanded mode which drastically modifies the fault currents.
Sergio D. Saldarriaga-Zuluaga +2 more
doaj +1 more source
A Switch Partial Turned OFF Cycle by Cycle Current Limiting Method for 3L-NPC Half-Bridge Inverters
IEEE Access, 2020 Instantaneous hardware protection is a very important method to protect inverters at the moment of over current or short circuit fault. For standalone inverters, the hardware protection can also be modified to achieve current limiting during the over ...
Xun Gao +5 more
doaj +1 more source
Energy Reports, 2022 Inverse time overcurrent protection can be applied to distribution networks with distributed power sources because of its superior protection characteristics, but its time limit coordination and value setting are complicated, which limits its large-scale
Yang Yu +4 more
doaj +1 more source
Protective coordination of main and backup overcurrent relays with different operating modes of active super-conducting current controller [PDF]
Maejo International Journal of Science and Technology, 2014 Active superconducting current controllers (ASCCs) are new generation of series compensators, which can also be categorised as fault current limiters because of their ability to decrease the fault current continuously.
Ahmad Ghafari +3 more
doaj +1 more source
Pakistan Journal of Engineering & Technology, 2022 Although traditional electromechanical circuit breakers have a proven track record as efficient and reliable circuit safety devices. Emerging power distribution technologies and architectures such as DC microgrids require advanced breaking performance ...
Muhammad Zulqair Nain, Tahir Mahmood
doaj +1 more source