Results 221 to 230 of about 3,811,701 (363)

Fingerprinting Uranium Oxides with Electron Energy Loss Spectroscopy Supported by Theoretical Computations. [PDF]

J Phys Chem A
Carbone J, Bártová B, La Grange T, Reinhold K, Leinders G, Torruella P, Hébert C, Sassi M, Bernier-Latmani R, Rosso KM.   +9 more
europepmc   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Hydrophilic Co-bonding Strategy of Cu-Cu and Al₂O₃-Al₂O₃ for 3D Integration. [PDF]

ACS Omega
Wang L, Ren K, Bai K, Chen H, Ding X, Yin L, Zhang J.   +6 more
europepmc   +1 more source

Oxidative eustress: the physiological role of oxidants

Science China Life Sciences, 2023
openaire   +2 more sources

Characterization of Aluminized Layers on Inconel‐738 Alloy: Microstructure, Modeling of Aluminizing Kinetics, and Thermal Behavior

Advanced Engineering Materials, EarlyView.
This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe, Tuba Yener, Suayb Cagri Yener, Mourad Keddam, Cuma Bindal   +4 more
wiley   +1 more source

The production and electrochemical performance analysis of an O3-NaTi_0.2Mn_0.2Fe_0.2Ni_0.2Co_0.2O₂ high-entropy oxide cathode for Na-ion batteries. [PDF]

RSC Adv
Topal A, Naveed A, Hetherington C, Gouttebaron R, Sahinbay S, Altin S.   +5 more
europepmc   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Modelling simple and complex metal-oxide and -hydroxide surface structures using their point of zero charge. [PDF]

RSC Adv
Leffler M, Suib SL.
europepmc   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Mechanical, thermal, structure and radiation shielding efficiency of natural kaolinite-based composites reinforced with heavy metal oxides. [PDF]

Sci Rep
Elsafi M, Alawaideh SE, Hamada MA, Sayyed MI.   +3 more
europepmc   +1 more source