Results 81 to 90 of about 40,291 (312)
Vortex-induced extinction behavior in methanol gaseous flames: a comparison with quasi-steady extinction [PDF]
Using a combination of HCHO planar laser-induced fluorescence and laser Doppler velocimetry measurements, the extinction behavior of methanol counterflow diffusion flames was examined experimentally under conditions in which the extinction was brought ...
Gomez, Alessandro +3 more
core +2 more sources
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Due to the safe operation and stability of non-premixed combustion, it can widely be utilized in different engineering power and medical systems. The current paper suggests a mathematical asymptotic technique to describe non-premixed laminar flow flames ...
Mehdi Bidabadi +4 more
doaj +1 more source
Conceptual design of the enhanced coolant purification systems for the European HCLL and HCPB test blanket modules [PDF]
The Coolant Purification Systems (CPSs) is one of the most relevant ancillary systems of European Helium Cooled Lead Lithium (HCLL) and Helium Cooled Pebble Bed (HCPB) Test Blanket Modules (TBMs) which are currently in the preliminary design phase in ...
Aiello A. +10 more
core +1 more source
This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Fluorine-containing oxidizers for metal fuels in energetic formulations
Fluorine containing oxidizers, primarily polymers, are extensively used in pyrotechnic compositions. Fluorinated oxidizers are less explored for metalized propellants and explosives despite a potential advantage of substantial heat release combined with ...
Siva Kumar Valluri +2 more
doaj +1 more source
Theoretical Analysis of Nitric Oxide Production in a Methane/Air Turbulent Diffusion Flame [PDF]
The coherent flame model is applied to the methane-air turbulent diffusion flame with the objective of describing the production of nitric oxide. The example of a circular jet of methane discharging into a stationary air atmosphere is used to illustrate ...
Marble, Frank E.
core
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source

