Results 201 to 210 of about 3,797,690 (364)

High‐Temperature Oxidation of the CrFeNi Medium‐Entropy Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
The oxidation behavior of equiatomic CrFeNi MEA is a key issue that determines this material's suitability for high‐temperature application. The understanding of long‐term behavior is even more crucial than short‐term corrosion effects. The alloy is exposed to synthetic air at 1000, 1050, and 1100 °C for 24, 100, and 1000 h and systematically compared ...
Anna Maria Manzoni   +5 more
wiley   +1 more source

CALPHAD‐Guided Prediction and Interpretation of Phase Formation in Ta–Mo–Cr–Ti–Al Refractory High‐Entropy Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
This study designs Ta–Mo–Cr–Ti–Al refractory high‐entropy alloys with a disordered body‐centered‐cubic A2 crystal structure aiming for improved ductility, lower density, and oxidation resistance. Four alloy compositions are identified by thermodynamic calculations.
Kateryna Khanchych   +7 more
wiley   +1 more source

CeO2 Nanostructures Prepared by Selective Water‐Soluble Sr3Al2O6(SAO)‐CeO2 Vertically Aligned Nanocomposite

open access: yesAdvanced Engineering Materials, EarlyView.
Highly textured CeO2 nanowires and nanoporous thin films are successfully synthesized by water dissolution of Sr3Al2O6 (SAO) from the SAO:CeO2 vertically aligned nanocomposites (VANs). The morphology of CeO2 can be varied by VAN composition. It demonstrates a new method for synthesizing nanostructured CeO2 without chemical etching or complex micro ...
Benson Kunhung Tsai   +8 more
wiley   +1 more source

Optimized Strategy for Fabricating High‐Aspect‐Ratio Periodic Structures Over Large Areas Using ps‐Direct Laser Interference Patterning

open access: yesAdvanced Engineering Materials, EarlyView.
Picosecond direct laser interference patterning (DLIP) enables precise microstructure fabrication on stainless steel. Using a multiscan approach, high‐aspect‐ratio patterns are achieved. Fluence influences structure growth and homogeneity, with smaller periods yielding better uniformity.
Fabian Ränke   +5 more
wiley   +1 more source

Sol–Gel Synthesis of Ca2.5Ag0.3Sm0.2Co4O9 Semiconducting Materials for Thermoelectric Applications in Aerospace Systems

open access: yesAdvanced Engineering Materials, EarlyView.
Ca2.5Ag0.3Sm0.2Co4O9 semiconductor materials are synthesized and produced in this study using the sol–gel and cold pressing techniques for thermoelectric generator applications. As template samples are added, the Seebeck coefficient and power factor values rise, peaking at 800 °C for Ca2.5Ag0.3Sm0.2Co4O9 at 274.47 μV K−1 and 0.58 mW mK−2, respectively.
Enes Kilinc   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy