Results 151 to 160 of about 331,915 (277)

Pain and Patient‐Reported Physical Function Did Not Differ Among Body Composition Profiles in Patients With Hip Osteoarthritis

open access: yesArthritis Care &Research, EarlyView.
Objective To explore whether higher body fat and lower lean mass are associated with greater pain and worse patient‐reported physical function in individuals with hip osteoarthritis (OA). A secondary aim was to examine whether pain and patient‐reported physical function differ according to four body composition profiles: high body fat, low lean mass ...
Alexandra Ryan   +10 more
wiley   +1 more source

Characteristics and Outcomes of Male Participants in a Multicenter Longitudinal Australian Study Cohort

open access: yesArthritis Care &Research, EarlyView.
Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin   +14 more
wiley   +1 more source

Rheumatoid Arthritis and Coronary Artery Calcium Progression: A Case Cohort Analysis from ELSA‐Brasil

open access: yesArthritis Care &Research, Accepted Article.
Objective To investigate the association between rheumatoid arthritis (RA) and coronary artery calcium (CAC) prevalence, incidence, and progression over four years in adults without prior cardiovascular disease. Methods A case‐cohort study within ELSA‐Brasil included 585 participants (86 RA, 499 controls). Longitudinal analyses were restricted to those
Patrícia Fonseca Estrada   +7 more
wiley   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

open access: yesAdvanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi   +3 more
wiley   +1 more source

Low‐Cost, Large‐Scale Nanoporous Metals by Mechanical Alloying, Oxide Reduction, and Dealloying of Powders

open access: yesAdvanced Engineering Materials, EarlyView.
Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley   +1 more source

Home - About - Disclaimer - Privacy