Results 101 to 110 of about 133,577 (291)

Tire-Pavement Friction Characteristics with Elastic Properties of Asphalt Pavements

open access: yesApplied Sciences, 2017
The skid-resisting performance of pavement is a critical factor in traffic safety. Recent studies primarily analyze this behavior by examining the macro or micro texture of the pavement.
Miao Yu   +3 more
doaj   +1 more source

HMA Pavement Performance and Durability

open access: yes, 2006
It has long been argued that at densities higher than approximately 92 percent (air void contents lower than 8 percent), a hotmix asphalt mixture is impermeable to water. However, as densities become lower (air void contents higher) than this, small decreases in the density can yield exponential increases in permeability.
del Pilar Vivar, Eliana   +1 more
openaire   +4 more sources

Wet runways [PDF]

open access: yes
Aircraft stopping and directional control performance on wet runways is discussed. The major elements affecting tire/ground traction developed by jet transport aircraft are identified and described in terms of atmospheric, pavement, tire, aircraft system
Horne, W. B.
core   +1 more source

Impact of Embedded Carbon Fiber Heating Panel on the Structural/Mechanical Performance of Roadway Pavement [PDF]

open access: yes, 2012
INE/AUTC 12 ...
Patil, Divendra   +4 more
core   +1 more source

Design and Prototyping of Topology‐Optimized, Additively Manufactured Lightweight Components for Space Robotic Systems: A Case Study

open access: yesAdvanced Engineering Materials, EarlyView.
The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos   +11 more
wiley   +1 more source

Contributions to predicting contaminant leaching from secondary materials used in roads [PDF]

open access: yes, 2004
Slags, coal ashes, and other secondary materials can be used in road construction. Both traditional and secondary materials used in roads may contain contaminants that may leach and pollute the groundwater.
Apul, Defne S
core   +2 more sources

Screen‐Printed Flexible Piezoelectric Force Sensor Array with Electromagnetic Interference Shielding

open access: yesAdvanced Engineering Materials, EarlyView.
This article introduces a flexible screen‐printed piezoelectric sensor array designed for low‐frequency healthcare applications such as tactile sensing and cardiovascular monitoring. The device integrates interface electronics enabling the simultaneous acquisition of up to 128 signals, along with flexible EMI shielding that significantly reduces noise ...
Joseph Faudou   +6 more
wiley   +1 more source

Using sensing, statistical, and numerical analysis approaches to evaluate the effect of temperature change on the resilient performance of highway pavements

open access: yesTransportation Engineering
The paper is to evaluate the effect of temperature change on the performance (i.e., roughness, mechanical response, etc.) of highway pavement using vehicle-based sensing technology, statistical analysis and numerical analysis.
Chun-Hsing Ho, Kewei Ren, Dada Zhang
doaj   +1 more source

Evaluation of Rumble Stripes on Low-Volume Rural Roads in Iowa—Phase II Final Report, November 2011 [PDF]

open access: yes, 2011
Single-vehicle run-off-road crashes are the most common crash type on rural two-lane Iowa roads. Rumble strips have proven effective in mitigating these crashes, but the strips are commonly installed in paved shoulders on higher-volume roads that are ...

core  

Enhancing Optoelectronic Properties in Phthalocyanine‐Based SURMOFs: Synthesis of ABAB Linkers by Avoiding Statistical Condensation with Tailored Building Blocks

open access: yesAdvanced Functional Materials, EarlyView.
A novel phthalocyanine (PC)‐based metal–organic framework (MOFs) is synthesized using ditopic PC linkers obtained through regioselective statistical condensation. The resulting MOF exhibits significant improvements in electronic absorption, thereby enhancing the material's performance in light harvesting and energy conversion.
Lukas S. Langer   +12 more
wiley   +1 more source

Home - About - Disclaimer - Privacy