Results 161 to 170 of about 167,242 (280)

Stroke-level performance fluctuation analysis in elite table tennis. [PDF]

open access: yesBMC Sports Sci Med Rehabil
Yu W, Zhou Z, Zhang H, Xie X.
europepmc   +1 more source

Euler‐Top Gaussian Modes: Structured Beams From Quadratic Angular Momentum Dynamics

open access: yesNanophotonics, Volume 15, Issue 9, 13 May 2026.
A new family of structured Gaussian light beams are introduced: Euler‐top Gaussian modes. Their ray‐orbital paths on the Gaussian Poincaré sphere correspond to the polhodes of the Euler top in classical angular momentum theory. This geometric and algebraic construction reveals a nonseparable mode family extending the familiar Hermite‐, Laguerre‐ and ...
Mark R. Dennis, Kerr Maxwell
wiley   +1 more source

Poly(L‐Lactide‐Co‐ ε ‐Caprolactone)/glass Fiber Composites: Toward Improved Mechanical Properties of Polylactide‐Based Composites

open access: yesPolymer Composites, Volume 47, Issue 9, Page 7812-7825, 10 May 2026.
Enhanced impact strength in PLLA‐based composites via ε‐caprolactone incorporation in the matrix. ABSTRACT Inherent brittleness and limited toughness of polylactide (PLA) restrict its use in high‐performance applications. To overcome these limitations, poly(L‐lactide) (PLLA) is often blended with more ductile thermoplastics or chemically modified ...
Bernard Miranda Campos   +4 more
wiley   +1 more source

Fused Filament Fabrication and Recycling of Bio‐Based Polyamide 11 Reinforced With Recycled Short Carbon Fibers

open access: yesPolymer Composites, Volume 47, Issue 9, Page 7909-7923, 10 May 2026.
Fused Filament Fabrication and Recycling of Bio‐Based Polyamide 11 Reinforced With Recycled Short Carbon Fibers. Sample preparation, mechanical properties improvement after rCF addition and properties retainment after recycling. ABSTRACT This research investigates the fused filament fabrication (FFF) and recycling of bio‐based polyamide 11 (PA11 ...
Mirko Coser   +2 more
wiley   +1 more source

Using Lignin and Spent Coffee Grounds as Bio‐Additives in 3D‐Printable Poly Lactic Acid/Multi‐Walled Carbon Nanotube Composites for Advanced Electronic Applications

open access: yesPolymer Composites, Volume 47, Issue 9, Page 8261-8272, 10 May 2026.
Bio‐based additives derived from lignin and spent coffee grounds (SCG) are used to enhance MWCNT dispersion in PLA composites, enabling improved electrical conductivity and reliable in material extruded strain‐gauge sensors. ABSTRACT In this work, three bio‐based additives, lignin, spent coffee grounds (SCG), and oil extracted from SCG (Ox‐SCG) were ...
Silvia Lage‐Rivera   +6 more
wiley   +1 more source

Safe Reconstruction of Posterior Sternoclavicular Dislocation Using a Palmaris Longus Autograft and ACL Tibial Guide Assistance: A Case Report

open access: yesClinical Case Reports, Volume 14, Issue 5, May 2026.
Use of an ACL tibial guide enables precise and safe tunnel placement during figure‐of‐eight reconstruction for posterior sternoclavicular joint dislocation, reducing the risk of mediastinal injury while restoring joint stability. ABSTRACT Posterior sternoclavicular joint (SCJ) dislocation is an uncommon but clinically significant injury due to its ...
Bilgehan Ocak   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy