Results 181 to 190 of about 8,524 (234)

Structural integrity assessment of an amphibious spider robot's flapping fin using FEA method for underwater operating conditions. [PDF]

Sci Rep
Marneni R, Ahmad KA, Zuber M, Singh S, Nair VG.   +4 more
europepmc   +1 more source

Functional evaluation of compatibilization systems for recycled PP-PET blends [PDF]

, 2018
Delva, Laurens, Kuzmanović, Maja, Mys, Nicolas, Ragaert, Kim, Wieme, Tom   +4 more
core  

Comparative mechanical performance of thermoplastic materials for clear aligners under simulated oral conditions. [PDF]

Korean J Orthod
Liu M, Wang Y, Bian C, Han Y, Qin X, Sun J, Bai Y, Zhang N.   +7 more
europepmc   +1 more source

Mechanical Characterization and Interface Evaluation of Multi-Material Composites Manufactured by Hybrid Fused Deposition Modeling (HFDM). [PDF]

Polymers (Basel)
Dağlı S.
europepmc   +1 more source

Direct observation of electrostatic charging in 3D printing. [PDF]

Nat Commun
Lorenzett E, da Campo YAS, Neto MAF, Burgo TAL.   +3 more
europepmc   +1 more source

Study on the Optimization of FDM Parameters for the Manufacture of Three-Point Bending Specimens from PETG and Recycled PETG in the Context of the Transition to the Circular Economy. [PDF]

Polymers (Basel)
Iacob DV, Zisopol DG, Minescu M.
europepmc   +1 more source

Metallization of 3D-Printed PET and PETG Samples with Different Filling Densities of the Inner Layers. [PDF]

Materials (Basel)
Petrova S, Lazarova D, Georgieva M, Petrova M, Dobrev D, Ditchev D.   +5 more
europepmc   +1 more source

Lensless light guide-coupled LED illumination for low-cost microscopy. [PDF]

HardwareX
Avery F, Geer T, Albrecht D.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Experimental Analysis of Mechanical properties of PETG Material 3D Printed Material by Using Fused Deposition Modelling Technique

2020
{"references": ["Steve Upcraft and Richard Fletcher (2003), \"The Rapid Prototyping Technologies\", Assembly Automat., ISSN: 0144-5154, Volume 23, Issue 4, pp. 318-330, DOI: 10.1108/01445150310698634.", "Ian Gibson, David W. Rosen and Brent Stucker (2010), \"Additive Manufacturing Technologies: Rapid Prototyping to Direct Digital Manufacturing\", New ...
Prajwal P. Agarwal, Tejas S. Dadmode, Kadav, Mahesh R., Amey P. Ogale, P. P. Mangave   +4 more
openaire   +1 more source

Identification of temperature-dependent parameters for an elastic–plastic-damage material model of 3D-printed PETG

Polymer, 2023
The presented paper focuses on identifying temperature-dependent parameters for a newly designed material model of 3D-printed PETG (polyethylene terephthalate glycol). An uniaxial elastic–plastic material model with damage and different properties in tension and compression was developed to describe this material’s non-linear behaviour.
Tereza Vaňková, Tomáš Kroupa, Robert Zemčík, Jan Krystek, Hana Zemčík   +4 more
openaire   +2 more sources