Results 11 to 20 of about 1,771,167 (311)
Composites Part C: Open Access, 2021 The present study aims to understand the high-temperature bending fatigue behavior at the stress-concentrated Y-shape junction of a component made of Tyranno SA3 fiber/BN interphase/SiC matrix composite.
Amit Patel +3 more
doaj +1 more source
Shock and Vibration, 2023 Compared with most dynamic tests, point load test is widely used in engineering practice because of its wide requirements for test conditions. In offshore mining engineering, the surrounding rock is affected by dynamic load impact and corrosion of ...
Ming Zhou, Lan Qiao, An Luo, Qingwen Li
doaj +1 more source
The use of point load test for Dubai weak calcareous sandstones
Journal of Rock Mechanics and Geotechnical Engineering, 2015 Intact rock is typically described according to its uniaxial compressive strength (UCS). The UCS is needed in the design of geotechnical engineering problems including stability of rock slopes and design of shallow and deep foundations resting on and/or ...
Amr Farouk Elhakim
doaj +1 more source
Wind tunnel test study on the wind load variation law of a point focus solar furnace
Frontiers in Energy Research, 2023 This work studied the wind load acting on a point focus solar furnace composed of a 110 m2 heliostat and a 77 m2 concentrator through wind tunnel testing.
Mingfei He +19 more
doaj +1 more source
XSS Vulnerability Detection Model Based on Dynamic Analysis [PDF]
Jisuanji gongcheng, 2018 Aiming at the problem of the failure rate and low detection efficiency in the XSS dynamic detection method,a new XSS vulnerability detection model is proposed.The model is divided into five parts:load cell generation,bypassing rule selection,exploratory ...
GU Jiateng,XIN Yang
doaj +1 more source
Design And Analysis Of Four-point Bending Test Rig For Ladder Frame
Journal of Applied Science and Engineering, 2022 This paper describes the design and analysis of a four-point bending test rig for ladder frame specimens. The test rig is used to support the specimen at two equal points when the transverse load is applied.
V. Y. Raj +5 more
doaj +1 more source
Buildings, 2022 Concrete is a brittle material whose tensile strength is about one-tenth of its compressive strength. Tensile strength is a key parameter for concrete under impact loading.
Jie Wang, Junlin Tao
doaj +1 more source
Test Loading of Structures with a Suspect Resistance
Applied Sciences, 2021 The reliability of load-bearing structures is normally secured through codes, a competent structural design and proper execution inspection. Alternatively, the reliability can be obtained via skilled test loading, which is a feasible technique both in ...
Tuomo Poutanen +2 more
doaj +1 more source
Factor influencing point load tests on concrete [PDF]
Asian Journal of Civil Engineering, 2018 The main purpose of this paper is to predict the in situ compressive strength of concrete by means of point load strength test as a partially destructive test method. This test method is examined by extracting core specimen from concrete blocks and applying two point loads to the lateral surface of the core specimen.
Madandoust, Rahmat +2 more
openaire +2 more sources
Geomechanics and Geology of Marine Terraces of the Crotone Basin, Calabria (Italy)
GeosciencesThis study investigates the geomechanical behavior of five terrace orders in the Crotone Basin. The purpose is to understand the physical–mechanical parameters of these terraces to determine whether rock or soil mechanics principles should be applied for
Gloria Campilongo +5 more
doaj +1 more source