Evaluation of the Influence of the Tool Set Overhang on the Tool Wear and Surface Quality in the Process of Finish Turning of the Inconel 718 Alloy. [PDF]
Materials (Basel)Smak K +5 more
europepmc +1 more source
Machinability Study of Hardened 1045 Steel When Milling with Ceramic Cutting Inserts. [PDF]
Materials (Basel), 2019 Shnfir M +3 more
europepmc +1 more source
Fabrication of Micro Carbon Mold for Glass-Based Micro Hole Array. [PDF]
Micromachines (Basel)Lee US, Sim DB, Lee JH, Kim BH.
europepmc +1 more source
Aluminum Matrix Composite (AlSi7Mg2Sr0.03/SiCp) Pistons Obtained by Mechanical Mixing Method. [PDF]
Materials (Basel), 2017 Dyzia M.
europepmc +1 more source
Considerations for Tungsten Carbide as Tooling in RFSSW. [PDF]
Materials (Basel)Belnap R, Smith T, Wright A, Hovanski Y.
europepmc +1 more source
The Influence of Tool Rake Surface Geometry on the Hard Turning Process of AISI52100 Hardened Steel. [PDF]
Materials (Basel), 2019 Xu H +6 more
europepmc +1 more source
Optimal fabrication of a thin-film thermocouple (TFTC) using Alumel/chromel junctions. [PDF]
HeliyonKim DM +4 more
europepmc +1 more source
On the Stability of c-BN-Reinforcing Particles in Ceramic Matrix Materials. [PDF]
Materials (Basel), 2018 Wolfrum AK +3 more
europepmc +1 more source
Impact of Mechanical Processes as a Pre-Sulphonitriding Treatment on Tribology Properties of Selected P/M Tool Steels. [PDF]
Materials (Basel), 2019 Toboła D.
europepmc +1 more source
Applied Mechanics and Materials, 2011 The samples of Polycrystalline cubic boron nitride (PcBN) cutting tool were machined by adjusting the main parameters of electrical discharge machining (EDM). After the machining, the phases were analyzed by X-ray diffraction analyzer and the surface layer microstructure was observed by scanning electronic microscope.
Yun Hai Jia
openaire +2 more sources