Results 131 to 140 of about 910 (167)

Fabrication of Micro Carbon Mold for Glass-Based Micro Hole Array. [PDF]

Micromachines (Basel)
Lee US, Sim DB, Lee JH, Kim BH.
europepmc   +1 more source

Aluminum Matrix Composite (AlSi7Mg2Sr0.03/SiC_p) Pistons Obtained by Mechanical Mixing Method. [PDF]

Materials (Basel), 2017
Dyzia M.
europepmc   +1 more source

Considerations for Tungsten Carbide as Tooling in RFSSW. [PDF]

Materials (Basel)
Belnap R, Smith T, Wright A, Hovanski Y.
europepmc   +1 more source

Optimal fabrication of a thin-film thermocouple (TFTC) using Alumel/chromel junctions. [PDF]

Heliyon
Kim DM, Kwak HJ, Shin DY, Park JH, Kim JY.   +4 more
europepmc   +1 more source

The Influence of Tool Rake Surface Geometry on the Hard Turning Process of AISI52100 Hardened Steel. [PDF]

Materials (Basel), 2019
Xu H, Zhou H, Ma Z, Dai L, Jing X, Li G, Sun Y.   +6 more
europepmc   +1 more source

On the Stability of c-BN-Reinforcing Particles in Ceramic Matrix Materials. [PDF]

Materials (Basel), 2018
Wolfrum AK, Matthey B, Michaelis A, Herrmann M.   +3 more
europepmc   +1 more source

Impact of Mechanical Processes as a Pre-Sulphonitriding Treatment on Tribology Properties of Selected P/M Tool Steels. [PDF]

Materials (Basel), 2019
Toboła D.
europepmc   +1 more source

Hybrid CO2 laser/waterjet (CO2-LWJ) cutting of Polycrystalline Cubic Boron Nitride (PCBN) blanks with phase transformation induced fracture

Optics and Laser Technology, 2015
Abstract The present paper investigates a transformation induced fracture mechanism for the cutting of Polycrystalline Cubic Boron Nitride (PCBN) sample by a hybrid CO2 laser/waterjet (CO2-LWJ) manufacturing process. In CO2-LWJ machining, a laser was used for local heating followed by waterjet quenching leading to fracture propagation along the ...
Zhuoru Wu, Ammar A Melaibari, Pranav Shrotriya   +2 more
exaly   +3 more sources

Embedding of micro thin film sensors into Polycrystalline Cubic Boron Nitride (PCBN) for tooling applications via diffusion bonding

International Journal of Mechatronics and Manufacturing Systems, 2009
The operative range of existing sensors is very limited with respect to withstanding harsh environments (high temperature or pressure, severe strains, etc.). Additionally, available sensors are limited in spatial and temporal resolution due to their large size. This paper reports on design, fabrication and characterisation of embedded sensors for harsh
Xiaochun Li
exaly   +3 more sources

An Investigation of the Wear Mechanisms of Polycrystalline Cubic Boron Nitride (PCBN) Tools when End Milling Hardened Steels at Low/Medium Cutting Speeds

The International Journal of Advanced Manufacturing Technology, 2001
3 min −1 . Carbide inserts were also tested under the same cutting conditions. The tests were carried out in the dry condition. Three different hardened steels were cut and the wear mechanism was investigated using a scanning electronic microscope (SEM). The minimal wear mechanism found was a combination of adhesion and abrasion.
A. Braghini Jr, R.T. Coelho
openaire   +2 more sources