Results 261 to 270 of about 82,392 (306)
Some of the next articles are maybe not open access.
Multilayer porous aluminosilicate ceramic
Glass and Ceramics, 2008Multilayer aluminosilicate materials used for treating drinking water were investigated. The basic results of the experimental studies obtained in developing the process conditions for fabrication of aluminosilicate filter elements are reported.
S. M. Azarov +4 more
openaire +1 more source
Strength of Highly Porous Ceramic Electrodes
Journal of the American Ceramic Society, 2011Highly porous ceramics are critical components of Solid Oxide Fuel Cells. Nevertheless, their mechanical properties are poor and not fully understood. Herein, Discrete Element simulations are used to quantitatively assess the relation between the particulate microstructure of highly porous ceramics and their mechanical properties.
Liu, X.X. +5 more
openaire +3 more sources
Ceramic porous materials with catalytic properties
Perspektivnye Materialy, 2019Undoubted leadership among catalytic materials for the purification of exhaust gases is occupied by composite cermets. Creation of catalytic materials for gas purification indicates that the main problem is partial or complete replacement of rare earth metals in their composition.
M. S. Kanapinov +4 more
openaire +1 more source
Porous PZT ceramics for receiving transducers
IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control, 2003PZT-air (porous PZT) and PZT-polymer (polymer impregnated porous PZT) piezocomposites with varying porosity/polymer volume fractions have been manufactured. The composites were characterized in terms of hydrostatic charge (dh) and voltage (gh) coefficients, permittivity, hydrostatic figure of merit (dh.gh), and absolute sensitivity (M). With decreasing
Hudai, Kara +3 more
openaire +2 more sources
Ceramics International, 1997
Abstract Ceramic gels are composed of colloidal particles or polymeric macro-molecules aggregated in a three-dimensional very open network. This paper addresses the network architecture of porous materials which can be made from these gels. The main parameters which have an influence on the pores, during the low temperature chemical procedure, as ...
openaire +2 more sources
Abstract Ceramic gels are composed of colloidal particles or polymeric macro-molecules aggregated in a three-dimensional very open network. This paper addresses the network architecture of porous materials which can be made from these gels. The main parameters which have an influence on the pores, during the low temperature chemical procedure, as ...
openaire +2 more sources
Advances in Bioceramics and Porous Ceramics III
2009This issue contains the proceedings of the "Porous Ceramics: Novel Developments and Applications" and "Next Generation Bioceramics" symposia, which were held on January 24-29, 2010 at the Hilton Daytona Beach Resort and the Ocean Center in Daytona Beach, Florida, USA.
R. NARAYAN, COLOMBO, PAOLO
openaire +6 more sources
Porous Piezoelectric Ceramics - A historical overview
2010 IEEE International Symposium on the Applications of Ferroelectrics (ISAF), 2010A brief review of porosity origin, microstructure peculiarities, fabrication methods, and mathematical models, as well as experimental data for different porous piezoceramics were presented. Critical comparison of FEM calculations with the results of various approximated formulas, unit cell models, and experimental data for porous piezoceramics was ...
openaire +1 more source
Ultra-high temperature ceramics for extreme environments
Nature Reviews Materials, 2023Elizabeth
exaly
Porous hydroxyapatite ceramics
Journal of Materials Science Letters, 1999A. ślósarczyk +2 more
openaire +1 more source