Results 11 to 20 of about 32,623 (137)
TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1997 A theoretical investigation of static characteristics at the start of operation is developed for a porous journal bearing with sealed ends lubricated only by the oil initially provided within its structures. Numerical results show that a negative pressure region exists in the porous matrix just below the oil-film rupture zone.
KANEKO, Satoru +2 more
openaire +2 more sources
Nihon Kikai Gakkai ronbunshu, 2019 This report describes the study on the lubrication characteristics of porous journal bearings, which were made with oil impregnated sintered materials having some hydrodynamic shapes, to apply them for a DC Spindle Motor’s bearing system. Herring Bone (I
Shigeru OHTSUKA +3 more
doaj +1 more source
Hydromagnetic Squeeze Film in Rough Porous Narrow Journal Bearing: A Study of Slip Effect
Tribology Online, 2017 This article aims to study the influence of slip on a hydromagnetic squeeze film in transversely rough porous narrow journal bearing. The Neuringer-Rosensweig model governs the fluid flow. The slip model of the Beavers and Joseph has been used.
Snehal Shukla, Gunamani Deheri
doaj +1 more source
LubricantsIn the present study, an effort was made to determine the effects of a porous matrix with different viscosities on the dynamic and static behaviors of rough short journal bearings taking into account the action of a squeezing film under varying loads ...
Neminath Bhujappa Naduvinamani +1 more
doaj +1 more source
The performance of a porous ceramic hydrostatic journal bearing
Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2009 The performance of a porous-ceramic hydrostatic journal bearing manufactured by the starch consolidation (SC) technique has been examined using a highly instrumented test rig. The results have been compared with those of a 5-recess hydrostatic bearing of the same size and comparable design, under the same testing conditions.
Durazo-Cardenas, Isidro +2 more
openaire +3 more sources
Computational model of sliding bearing
Advanced Engineering Research, 2017 Introduction. Refined computational models of tribosystems taking into account the dependence of viscosity and permeability of the porous coating on pressure through partial filling of the front gap with lubricant are described.
Maria A. Savenkova, Konstantin S. Solop
doaj +1 more source
Al-Khawarizmi Engineering Journal, 2012 In this paper, a theoretical study to the effect of journal misalignment on the static characteristics of oil filled porous journal bearing when lubricated with couple stress fluid has been carried out.
Lekaa' H. Abd Al-shaheed
doaj +2 more sources
Cerâmica, 2010 This paper presents the development of an advanced ceramic material for manufacturing aerostatic porous bearing. The results show that there is homogeneous distribution of the pores in the alumina matrix by using different concentrations of the added ...
Z. C Silveira +3 more
doaj +1 more source
Theoretical Investigation of Starved Porous Journal Bearings Anisotropic Permeability with
مجلة النهرين للعلوم الهندسية, 2009 The present study is a theoretical analysis to evaluate the static characteristics of oil filled porous journal bearing with non uniform permeability using an improved boundary condition.
Basim A. Abass, Liqaa H. Abd-Alsheed
doaj
Applied MechanicsThe performance of the porous gas bearing depends on the geometric characteristics, material, fluid properties, and the properties of the porous media, which is a restrictor that controls the gas flow.
Azael Duran-Castillo +4 more
doaj +1 more source