Results 21 to 30 of about 5,586 (187)
Photothermal, macroporous lignin‐based cryogels are engineered to convert sunlight into low‐grade heat. Integrated as stacked beds in a drum‐type device, a thin copper interlayer transfers waste heat between beds, enabling interlayer heat recovery and continuous solar cycling.
Jie Yan +8 more
wiley +1 more source
ACC forms via aggregating prenucleation clusters that gatekeep its chemical composition. Ion identity steers the path: Ba and Sr substitute Ca in clusters, thereby inhibiting nucleation, with a dose‐dependent switch of Sr to induction. Mg partitions into Mg‐rich and Mg‐poor clusters; the latter form ACC, expelling Mg.
Qianyu Zhao +9 more
wiley +1 more source
Understanding thermal battery behavior is essential for performance, safety, and longevity in automotive applications. This work presents a method to determine entropic‐heat coefficients using continuous quasi‐open‐circuit‐voltage measurements. The method's accuracy and robustness are validated through comparison with potentiometric measurements ...
Anne Heß +2 more
wiley +1 more source
Points of Zero Charge and Potentiometric Titrations
Based on the various categories of surface charge and the definitions of points of zero charge proposed by Sposito (1984, 1998), the determination of the adsorbed proton charge (σ H ) and the point of zero net charge (PZNPC) of insoluble oxides and layer
Tao Zuyi, Chu Taiwei
doaj +1 more source
Synthesis of trimethylolpropane trioleate by using stannous oxalate catalyst
Abstract This study was conducted to synthesize trimethylolpropane trioleate (TMPTO) using a stannous oxalate catalyst and investigate the dependence of the esterification rate on reaction variables. The highest esterification rate of approximately 99% was achieved at a 2.75:1 oleic acid/trimethylolpropane, 1.5% catalyst amount, 180°C reaction ...
Oguzhan Ilgen, Sumeyye Bilgic
wiley +1 more source
Real‐time quality and safety monitoring of fruit juice using paper‐based platform
Schematic illustration of a paper‐based biosensor for rapid detection of fruit juice spoilage. Abstract Food spoilage and safety concerns still remain critically challenging within the fruit juice industry, especially as conventional detection methods, though precise, are often too time‐consuming, costly, and reliant on centralized laboratories.
Priti Das +4 more
wiley +1 more source
A personal 360° view of applications of ‘biomimetic’ molecular recognition
Abstract Molecular recognition between biological molecules has formed the basis for innumerable applications in biotechnology for the last seven decades or so. Techniques such as affinity chromatography, solid‐phase and aqueous two‐phase extraction, affinity precipitation, biomimetic catalytic systems, biosensors and molecular imprinting all exploit ...
Christopher R Lowe
wiley +1 more source
BACKGROUND The analysis of six indices (pH, total alkalinity, chloride ion, calcium ion, magnesium ion and sulfate radical) in underground water needed to be sampled separately for each index. The steps were tedious with low efficiency.
ZHAO Wen-jie +5 more
doaj +1 more source
Equations for potentiometric titration [PDF]
Examines some difficulties arising with assumptions made in a previously published experiment.
Ann Lomax, Allen J. Bard
openaire +1 more source
Abstract Consistent monitoring of seawater spectrophotometric pH on the total hydrogen ion scale (pHT) has been questioned by an evolving method, with changes in parameterization and the purity of the meta‐cresol purple (mCP). Using real seawater samples, we demonstrate that spectrophotometric pHT measurements obtained with unpurified (UNPUR) and ...
Marta Álvarez +6 more
wiley +1 more source

