Results 251 to 260 of about 218,831 (310)

A Super-Capacitive Pressure Sensor with Ultrahigh Sensitivity and Wide Linear Pressure Sensing Range for Human Bio-Signal Detection and Electronic Skin. [PDF]

open access: yesAdv Sci (Weinh)
Cheng AJ   +12 more
europepmc   +1 more source

MXene-Based High-Performance Soft Pressure Sensor Using Gel-Deep Eutectic Solvent Composite. [PDF]

open access: yesMicromachines (Basel)
Sasaki R   +8 more
europepmc   +1 more source
Some of the next articles are maybe not open access.

Related searches:

A pressure sensor of the industry

Proceedings of 2011 International Conference on Electronic & Mechanical Engineering and Information Technology, 2011
A pressure sensor structure of the industry is adopted in this paper. The reliability and stability of the sensor are analyzed understand the high pressure situation. Detailed introduction and study are carried out for the particular sensor chip and 10MPa high work pressure is loaded on the sensor chip for performance analysis. Through the analysis, we
Ling Shi, Chunlei Sun, Qing'en Li
openaire   +1 more source

A micromachined pressure/flow-sensor

Sensors and Actuators A: Physical, 1999
The micromechanical equivalent of a differential pressure flow-sensor, well known in macro mechanics, is discussed. Two separate pressure sensors are used for the device, enabling to measure both, pressure as well as volume flow-rate. An integrated sensor with capacitive read-out as well as a hybrid, piezo-resistive variant is made.
Oosterbroek, R.E.   +5 more
openaire   +1 more source

Biocompatibility of a physiological pressure sensor

Biosensors and Bioelectronics, 2003
A newly developed fiber optic micropressure sensor was evaluated for biocompatibility using the International Organization for Standardization (ISO) test standard 10993-6. The test material and an inert control (fused silica glass) were tested in New Zealand white rabbits.
Chao, Yang   +3 more
openaire   +2 more sources

A silicon piezoresistive pressure sensor

Proceedings First IEEE International Workshop on Electronic Design, Test and Applications '2002, 2003
The paper describes the design, simulation and fabrication of a silicon pressure sensor. The device makes use a of monocrystalline silicon square diaphragm supported by a thick silicon rim. The diaphragm is fabricated by etching away the bulk silicon on a defined region until the required thickness is achieved.
Ranjit Singh   +3 more
openaire   +1 more source

Home - About - Disclaimer - Privacy