Results 231 to 240 of about 660,436 (258)
Some of the next articles are maybe not open access.
Combined pulsing currents and agitation for electrodeposition
Transactions of the IMF, 2014In order to exploit the full potential of current pulsing one may need to combine it with synchronised and pulsing solution agitation. The problem with providing pulsing agitation is that changes in the momentum boundary layer have a much larger time constant than that required for changing reaction conditions at the electrode surface.
Coleman S, Roy S
openaire +2 more sources
Effect of pulse parameter on pulsed electrodeposition of copper on stainless steel
Surface Engineering, 2009The pulsed electrodeposition of copper on stainless steel has been studied in copper sulphate bath and the effect of duty cycle and frequency on the thickness and current efficiencies were compared at 50°C and at room temperature with average current density of 4 A dm −2 .
Balasubramanian, A. +4 more
openaire +1 more source
Pulsed electrodeposition of Cu2ZnSnS4 thin films: Effect of pulse potentials
Applied Surface Science, 2015Abstract Cu2ZnSnS4 (CZTS) thin films are electrodeposited on Mo substrate using pulsed electrodeposition (PED) at different pulse potentials. The pulse potential (V1) is varied from 0 V/SCE to −0.9 V/SCE and V2 fixed at −1.1 V/SCE. The effects of pulse potentials on the properties of CZTS thin films are investigated.
K.V. Gurav +11 more
openaire +1 more source
Metals and Materials International, 2019
CoCrFeMnNi high entropy alloy (HEAs) thin films were prepared using the pulse electrodeposition method. The films were co-deposited in an electrolyte based on an N,N-dimethylformamide—acetonitrile (CH3CN) organic system containing Co, Cr, Fe, Mn, and Ni chloride cations using the pulse electrodeposition method at frequencies of 2500 and 5000 Hz as well
Fateme Yoosefan +3 more
openaire +1 more source
CoCrFeMnNi high entropy alloy (HEAs) thin films were prepared using the pulse electrodeposition method. The films were co-deposited in an electrolyte based on an N,N-dimethylformamide—acetonitrile (CH3CN) organic system containing Co, Cr, Fe, Mn, and Ni chloride cations using the pulse electrodeposition method at frequencies of 2500 and 5000 Hz as well
Fateme Yoosefan +3 more
openaire +1 more source
Pulse Plated Electrodeposition of CuInSe2 Films
Journal of The Electrochemical Society, 1987The CuInSe/sub 2/ films are deposited using pulse plating technique from an aqueous acidic bath. The following are the suitable conditions getting stoichiometric CuInSe/sub 2/ films: pulse height, - 840 mV(SCE); duty cycle, 33% (5 ms on, 10 ms off); deposition temperature 25/sup 0/C; substrate, polished titanium.
openaire +1 more source
HEAVY ELECTRODEPOSITION OF RHODIUM BY PULSE CURRENT.
2012Heavy electrodeposition of rhodium is required for various industrial applications. However, cracking of the coating is observed under dc. Thus, the pulse current method was studied and a crackfree thick deposit was obtained under a wide range of operating parameters.
Miu, WS, Fung, YS
openaire +1 more source
Electrode Fabrication for Proton Exchange Membrane Fuel Cells by Pulse Electrodeposition
Journal of Power Sources, 1998Tae Hee Lee
exaly
Pulse Current Electrodeposition of Manganese Metal From Sulfate Solution
Journal of Environmental Chemical Engineering, 2019Xingran Zhang +2 more
exaly

