Results 21 to 30 of about 3,051 (232)

1D simulation of pump-turbine transition [PDF]

open access: yesJournal of Physics: Conference Series, 2017
Variable speed motor-generators based on full size converter offer new options for operation of reversible pump-turbines. To explore the challenges related with this new technology a specific test rig configuration is developed to perform such transition with a PT reduced scale model.
N Ruchonnet, O Braun
openaire   +1 more source

Research on configuration and performance of water ramjet pressurized water intake system

open access: yesXibei Gongye Daxue Xuebao, 2023
Water ramjet is the most ideal power propulsion device for high-speed underwater weapons. However, failure to start it at low-speed makes it hard for the engine to be widely used.
YANG Hao   +5 more
doaj   +1 more source

Optimal parameters of elliptical groove gas film face seal with bidirectional rotational characteristics [PDF]

open access: yesInternational Journal of Fluid Engineering
The performance of gas film face seals is substantially affected by the geometric features of the texture on the seal face. To enhance the design of elliptical groove face seals for efficient bidirectional rotation, a comprehensive theoretical analysis ...
Yuansen Song   +3 more
doaj   +1 more source

Stress Characteristic Analysis of Pump-Turbine Head Cover Bolts during Load Rejection Based on Measurement and Simulation

open access: yesEnergies, 2022
It is not uncommon for pump-turbine units in pumped storage power plants to experience load rejections due to the sudden disconnection of the generator from the power grid.
Xingxing Huang   +7 more
doaj   +1 more source

Compressible Simulation of Rotor-Stator Interaction in Pump-Turbines [PDF]

open access: yesInternational Journal of Fluid Machinery and Systems, 2010
This work investigates the influence of water compressibility on pressure pulsations induced by rotor-stator interaction (RSI) in hydraulic machinery, using the commercial CFD solver ANSYS-CFX. A pipe flow example with harmonic velocity excitation at the inlet plane is simulated using different grid densities and time step sizes.
J Yan, J Koutnik, U Seidel, B Hübner
openaire   +1 more source

Computational Analysis on Numerical Simulation of Internal Flow Physics for Pump as Turbine in Renewable Small Hydro Energy Generation

open access: yesComplexity, 2020
Energy contributes significantly in almost all aspects of human life as well as economic activities and plays a crucial role in the infrastructural development of a county to alleviate poverty.
Du Jianguo   +4 more
doaj   +1 more source

Measuring the Dynamic Characteristics of a Low Specific Speed Pump—Turbine Model

open access: yesEnergies, 2016
This paper presents results from an experiment performed to obtain the dynamic characteristics of a reversible pump-turbine model. The characteristics were measured in an open loop system where the turbine initially was run on low rotational speed before
Eve Cathrin Walseth   +2 more
doaj   +1 more source

Selective hydrometallurgical recovery of gold by using low-cost biomass waste: Kiwi peel

open access: yesAdsorption Science & Technology
Utilization of kiwi peel (KP) is proposed for gold recovery from electronic wastes (e-wastes). KP was simply modified by dehydration pretreatment with concentrated sulfuric acid.
Dan Yu, Xiaomei Guo, Yang Liu
doaj   +1 more source

Cavitation measurements on a pump-turbine model

open access: yesJournal of Physics: Conference Series, 2015
When a hydraulic turbine is operated at off-design conditions, cavitation on the runner and other machine parts can occur. Vibration, noise and erosion caused by cavitation can damage the turbine and lead to a limitation of the operational range. To avoid damage of the turbine, it is fundamental to get knowledge of the presence of cavitation.
H Schmidt, O Kirschner, S Riedelbauch
openaire   +1 more source

Biodegradable and Biocompatible Functional Polymers for Biomedical Applications

open access: yesAdvanced Functional Materials, EarlyView.
Biodegradable and biocompatible functional polymers integrate electrical, mechanical, and stimuli‐responsive functionalities while enabling programmed degradation under physiological conditions. This review introduces recent advances in conductive, shape‐memory, self‐healing, photocurable, and adhesive polymer systems, emphasizing material design ...
Won Bae Han   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy