Results 41 to 50 of about 96 (94)
High Voltage, EarlyView.ABSTRACT The emergence of (ultra)wide bandgap ((U)WBG)‐based devices has significantly enhanced performance in high‐frequency switching applications, enabling breakthroughs in electric transportation, aerospace, and renewable energy systems. However, it also presents considerable challenges to insulation systems, such as electric motor winding ...
Easir Arafat +3 more
wiley +1 more source
IET Electric Power ApplicationsFive‐phase permanent magnet synchronous machine (PMSM) can operate under open‐circuit faults with the appropriate current regulations. However, the traditional current regulations based on the five‐phase half‐bridge inverter have to satisfy the ...
Lijian Wu +3 more
doaj +1 more source
Reliability study on DC-link capacitor in fault states of VSI in elective vehicle
The Journal of Engineering, 2019 DC-input side of the inverter to balance input and output power, eliminate voltage fluctuation, and reduce the voltage spike in the input side. The reliability study on DC-link capacitor under fault state is critical to the safe operation of the whole ...
Fang Yao +3 more
doaj +1 more source
High Voltage, EarlyView.ABSTRACT The alternate arm converter (AAC) is one of the most efficient multilevel topologies based on voltage source converters (VSCs), which has recently gained attention in various applications, particularly in high voltage direct current (HVDC) systems.
Ehsan Akbari, Milad Samady Shadlu
wiley +1 more source
The Journal of Engineering, 2014 Closed-form analytical formulas are provided to calculate the dc bus harmonics of a three-phase sinusoidal pulse width modulation (SPWM) inverter. The harmonic analysis is performed by using a double Fourier series approach to determine the dc bus ...
Saeid Haghbin +2 more
doaj +1 more source
IET Smart Energy Systems, EarlyView.The Graphical Abstract depicts the proposed Artificial Bee Colony algorithm‐based optimal tuning of PI controllers for back‐to‐back Voltage Source Converters in a hybrid wind–PV system. ABSTRACT This paper proposes a hybrid model‐based back‐to‐back voltage‐source converter (B2B‐VSC) system comprising a Photovoltaic (PV) array and a Permanent Magnet ...
Ch. Sreenu +3 more
wiley +1 more source
Design of a 100 kHz wide bandgap inverter for motor applications with active damped sine wave filter
The Journal of Engineering, 2019 In this study, a three-phase motor inverter with sinusoidal output voltages based on the application of gallium nitride transistors and advanced control is analysed.
Franz Maislinger +4 more
doaj +1 more source
Sequential Outlier Detection in Nonstationary Time Series
Journal of Time Series Analysis, EarlyView.ABSTRACT A novel method for sequential outlier detection in nonstationary time series is proposed. The method tests the null hypothesis of “no outlier” at each time point, addressing the multiple testing problem by bounding the error probability of successive tests, using extreme‐value theory. The asymptotic properties of the test statistic are studied
Florian Heinrichs +2 more
wiley +1 more source
A new three‐level simplified sparce NPC topology for UHS PMSM motor applications
IET Electric Power ApplicationsIn ultra‐high speed (UHS) motor applications, full SIC two‐level (2L) inverters with high switching frequencies are generally used due to their lower cost.
Aleksandr Sheianov, Xi Xiao, Xudong Sun
doaj +1 more source
900 V GaN-based sine-wave inverters for three-phase industrial applications
The Journal of Engineering, 2019 GaN devices are gradually getting attention within the industry along with SiC as a potential wide bandgap device. At present, there are almost no high-voltage GaN devices with voltage >650 V, which makes an inverter design difficult for a three-phase ...
Nilanjan Mukherjee +3 more
doaj +1 more source