Results 31 to 40 of about 39,996 (261)
Why human connection is the true metric of research success
Human‐centred mentorship can be shaped by mentor attributes, actions, intrinsic drive and career ambition. Drawing on reflections across Singapore and France, as well as workshop insights from FEBS‐IUBMB ENABLE 2024, this article shows that human‐centred mentorship creates the conditions for sustainable growth, well‐being and retention in research ...
Timothy Lin Yun Tan +3 more
wiley +1 more source
The high frequency isolated quasi Z-source inverter is a new type of inverter, which is suitable for photovoltaic generation system because of its high lift to voltage ratio, transient bridge direct access and electrical isolation.With the increase of ...
Yan Chen +3 more
doaj +1 more source
Hybrid Source Multi-Port Quasi-Z-Source Converter with Fuzzy-Logic-Based Energy Management
In this paper, a fuzzy-logic-based energy management system and a multi-port quasi-z-source converter that utilizes hybrid renewable energy sources are proposed.
Gorkem Say +2 more
doaj +1 more source
Analysis and modeling of the Quasi-Z-Source-Inverter
This paper presents a dynamic average model of the Quasi-Z-Source Inverter (QZSI), based on the short term average values over one PWM-period, and the analysis of the possible switching states that can occur in the QZSI. The model is considerably descriptive since the modeling has been performed by analyzing the physical and functional relations with ...
Liske, A., Clos, G., Braun, M.
openaire +3 more sources
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source
In this paper, switched Z-source/quasi-Z-source dc-dc converters (SZSC/SQZSCs) are proposed for the photovoltaic (PV) grid-connected power system, where the high step-up dc-dc converters are required to boost the low voltage to high voltage.
Junfeng Liu +3 more
doaj +1 more source
Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Compound robust control of permanent magnet synchronous motor based on quasi‐Z source inverter
In this study, a compound control strategy for motor side and quasi‐Z source side is proposed to improve the robustness of the quasi‐Z source permanent magnet synchronous motor drive system subjected to external disturbance.
Fan Peng, Weicai Xie, Jiande Yan
doaj +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source

