Results 51 to 60 of about 7,548,261 (298)

Compound robust control of permanent magnet synchronous motor based on quasi‐Z source inverter

open access: yesIET Electric Power Applications, 2023
In this study, a compound control strategy for motor side and quasi‐Z source side is proposed to improve the robustness of the quasi‐Z source permanent magnet synchronous motor drive system subjected to external disturbance.
Fan Peng, Weicai Xie, Jiande Yan
doaj   +1 more source

Extended family of DC-DC Quasi-Z-Source converters

open access: yesInternational Journal of Electrical and Computer Engineering (IJECE), 2019
The family of DC-DC q-ZSCs is extended from two to three classes and four to six members. All the members were analyzed based on efficient duty ratio range (R<sub>Deff</sub>) and general duty ratio range (R<sub>Dgen</sub>). Findings showed that similar to the traditional buck-boost converter (BBC), each of the topologies is ...
Ado, M., Jusoh, A., Sutikno, T.
openaire   +4 more sources

Microstructure‑Dependent Phase Transformations Under High‑Pressure Laser Heating in Additively Manufactured AlCrFe2Ni2

open access: yesAdvanced Engineering Materials, EarlyView.
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika   +5 more
wiley   +1 more source

Cascadable Enhanced Quasi‐Z‐Source Inverter with Reduced Current Stress

open access: yesIET Power Electronics
In magnetically coupled impedance source (MCIS) inverters, the turn ratio of the coupled inductor offers design flexibility. The leakage inductance, however, poses additional challenges, mainly voltage spikes.
Ahmad Mahdave   +3 more
doaj   +1 more source

Modeling and Analysis of Quasi-Z Source IMC Converter Feeding PMSM Drive System

open access: yesTikrit Journal of Engineering Sciences
The purpose of this study is to increase the voltage gain (U_g) for a quasi-Z-source indirect matrix converter (IMC) feeding a three-phase Permanent Magnet Synchronous machine (PMSM) drive system.
Ahmed K. Hannan   +4 more
doaj   +1 more source

Multistring seven-level quasi Z-source based asymmetrical inverter [PDF]

open access: yes, 2019
In this paper, a single-phase multistring seven-level Quasi-Z-source based Asymmetrical Inverter suitable for grid-connected photovoltaic (PV) system is presented.
Annamalai, Kirubakaran   +1 more
core   +1 more source

All‐in‐One Analog AI Hardware: On‐Chip Training and Inference with Conductive‐Metal‐Oxide/HfOx ReRAM Devices

open access: yesAdvanced Functional Materials, EarlyView.
An all‐in‐one analog AI accelerator is presented, enabling on‐chip training, weight retention, and long‐term inference acceleration. It leverages a BEOL‐integrated CMO/HfOx ReRAM array with low‐voltage operation (<1.5 V), multi‐bit capability over 32 states, low programming noise (10 nS), and near‐ideal weight transfer.
Donato Francesco Falcone   +11 more
wiley   +1 more source

Quasi-Z-Source three-phase rectifier modelling and control [PDF]

open access: yes, 2013
Dissertation (MEng (Electrical Engineering))--University of Pretoria, 2013.AC to DC rectifiers are used as front-end interface in multiple applications with DC load or in inverter fed from line voltage.

core  

Virtual Inertia Implemented by Quasi-Z-Source Power Converter for Distributed Power System

open access: yesEnergies, 2023
This paper proposes a novel virtual inertia control strategy for distributed power systems with high penetration of renewable energy sources. The strategy uses a quasi-Z-source power converter to emulate the inertia response of a synchronous generator by
Yitao Liu, Hongle Chen, Runqiu Fang
doaj   +1 more source

Printed Integrated Logic Circuits Based on Chitosan‐Gated Organic Transistors for Future Edible Systems

open access: yesAdvanced Functional Materials, EarlyView.
Edible electronics needs integrated logic circuits for computation and control. This work presents a potentially edible printed chitosan‐gated transistor with a design optimized for integration in circuits. Its implementation in integrated logic gates and circuits operating at low voltage (0.7 V) is demonstrated, as well as the compatibility with an ...
Giulia Coco   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy