Results 91 to 100 of about 26,215 (293)

Generation of superoxide and singlet oxygen from α-tocopherolquinone and analogues. [PDF]

open access: yes, 2007
Three potential routes to generation of reactive oxygen species from a tocopherolquinone have been identified. The quinone of the water-soluble vitamin E analogue Trolox C (Trol-Q) is reduced by hydrated electron and isopropanol a hydroxyalkyl radical ...
Bisby, RH   +4 more
core   +1 more source

Numerical Exploration of Thermal Shock Resistance in MgO–C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
A mesostructure‐resolved numerical framework is developed to evaluate the thermal shock resistance of MgO–C refractories. By modeling interface debonding under rapid temperature changes and introducing a modified thermal shock parameter that accounts for mesocracks, the study shows how graphite content and aggregate size influence thermal shock ...
Jishnu Vinayak Gopi   +3 more
wiley   +1 more source

Sensitized photolysis of polychlorobiphenyls in alkaline 2-propanol: dechlorination of Aroclor 1254 in soil samples by solar radiation [PDF]

open access: yes, 1992
Photodechlorination of Aroclor 1254 (1000 mg/L) in an alkaline 2-propanol solution at \lambda = 254 nm proceeded with a high quantum yield (\phi = 35.0) as determined by C1- release.
Demeter, Attila   +2 more
core   +1 more source

Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing

open access: yesAdvanced Engineering Materials, EarlyView.
The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai   +6 more
wiley   +1 more source

Austenite Reverse Transformation in a Q&P Route of Mn and Ni Added Steels

open access: yesMetals, 2020
In this work, four low carbon steels with different contents of Mn and Ni were heat treated by quenching and partitioning (Q&P) cycles where high partitioning temperatures, in the range of 550 °C–650 °C, were applied.
Maribel Arribas   +8 more
doaj   +1 more source

Prompt Formation of Organic Acids in Pulse Ozonation of Terpenes on Aqueous Surfaces [PDF]

open access: yes, 2010
A major atmospheric process, the gas-phase ozonation of terpenes yields suites of products via a cascade of chemically activated intermediates that ranges from primary ozonides to dioxiranes.
Colussi, A. J.   +2 more
core   +2 more sources

Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment

open access: yesAdvanced Engineering Materials, EarlyView.
This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li   +5 more
wiley   +1 more source

Solute trapping and diffusionless solidification in a binary system

open access: yes, 2007
Numerous experimental data on the rapid solidification of binary systems exhibit the formation of metastable solid phases with the initial (nominal) chemical composition.
Galenko, Peter
core   +3 more sources

Models and measurements of energy-dependent quenching. [PDF]

open access: yes, 2013
Energy-dependent quenching (qE) in photosystem II (PSII) is a pH-dependent response that enables plants to regulate light harvesting in response to rapid fluctuations in light intensity.
Amarnath, Kapil   +3 more
core   +1 more source

Evaluation of Plasticity and Creep Parameters From Tensile Stress–Strain Data for a Range of Strain Rates

open access: yesAdvanced Engineering Materials, EarlyView.
This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley   +1 more source

Home - About - Disclaimer - Privacy