Results 21 to 30 of about 2,311,305 (201)
Microstructure Effects of the Electrical Discharge Machining Drill on Aerospace Super Alloys
Advances in Materials Science and Engineering, 2022 This paper presents an analysis of the parent material damage and electrode wear of a handheld electrical discharge machining (EDM) drill. The motivation of this study is to investigate the material effects of EDM drilling on aerospace alloys at a ...
Garner Copher +6 more
doaj +1 more source
Journal of Materials Research and Technology, 2023 Inadequate research regarding how material characteristics affect vital yield parameters in EDM, particularly for aluminium, brass, and Inconel 617. An limited study has examined how EDM process parameters like peak current (Ip), gap voltage, and pulse ...
Kamlesh Paswan +6 more
doaj +1 more source
The thickness of the calcified layer in different joints of a single individual [PDF]
, 1987 The thickness of the articular cartilage and its calcified zone were both measured at specially chosen places in several limb joints from five subjects.
Müller-Gerbl, Magdalena +2 more
core +1 more source
Experimental Investigation of Recast Layer, Heat Affected Zone and Corrosion Resistance in WEDM of Inconel 617 [PDF]
, 2020 In this investigation, the effects of input parameters of wire electrical discharge machining (WEDM) process such as pulse current and pulse duration on recast layer thickness (RLT) and heat affected zone depth (HAZ) in machining of Inconel 617 was ...
Gholipoor, Ahad ; Department of Mechanical Engineering, University of Tabriz, Tabriz, Iran +2 more
core +3 more sources
Advances in Materials Science and Engineering, 2022 Ti-6Al-4V is known for its lightweight, high tensile strength, exceptional corrosion resistance, and low thermal coefficient of expansion due to which it finds its application in precision surgical instruments and aeronautical and marine engine parts. In
R. Manoj Samson +6 more
doaj +1 more source
Micromachines, 2022 An experiment using water-assisted millisecond laser trepanning on superalloy GH4220 was carried out, and the effects of pulse energy on the hole entrance morphology, diameter, roundness, cross-section morphology, taper angle, sidewall roughness, and ...
Liang Wang +4 more
doaj +1 more source
High‐Quality Femtosecond Laser Surface Micro/Nano‐Structuring Assisted by A Thin Frost Layer
Advanced Materials Interfaces, 2023 Femtosecond laser ablation has been demonstrated to be a versatile tool to produce micro/nanoscale features with high precision and accuracy. However, the use of high laser fluence to increase the ablation efficiency usually results in unwanted effects ...
Wenhai Gao +11 more
doaj +1 more source
Influence of Process Parameters on the Microstructural Characteristics and Mechanical Properties of Recast Layer Thickness Coating on Die Steel Machined Surface after Electrical Discharge Machining [PDF]
International Journal of Engineering, 2021 The surface layer machined after electrical discharge machining (EDM) is different from it after traditional methods, and studying the surface layer structure machined by this method will contribute significantly to the selection of finishing methods.
openaire +1 more source
Metals, 2023 Electrical Discharge Machining (EDM) is a machining method commonly used to produce complex shapes and deep holes by eroding hard metals with an electric arc.
Liwei Li +8 more
doaj +1 more source
The thickness of the calcified layer of articular cartilage [PDF]
, 1987 The thickness of both the articular cartilage and its calcified zone were measured at 25 carefully selected points in 8 human femoral heads, and the ratio of one to the other was found to be remarkably constant for each bone.
Müller-Gerbl, Magdalena +2 more
core +1 more source