Results 181 to 190 of about 67,105 (299)

Heavier Alkyne‐Ni0 Complexes, [R2E2·Ni] (E = Sn, Pb), Exhibiting σ‐Complex Character

open access: yesAngewandte Chemie, EarlyView.
Using a reductive group elimination strategy, heavier alkyne (LEEL; E = Sn, Pb) complexes of Ni0 are accessed. In contrast to classical alkyne coordination, these systems are best described as σ‐complexes, driven by ligand‐induced constraints and the established poor π‐bonding in heavier alkyne analogues.
Leopold Junge   +3 more
wiley   +2 more sources

Effects of Drying on Energetic Materials Produced by Spray Flash Evaporation. [PDF]

open access: yesACS Omega
Thomas G   +5 more
europepmc   +1 more source

Vapor‐Phase Grain‐Boundary Anchoring Enables Molecular Toughening and Record Bending Endurance in Pilot‐Scale Roll‐to‐Roll‐Printed Flexible Perovskite Modules

open access: yesAngewandte Chemie, EarlyView.
A vapor‐phase molecular toughening strategy is developed for pilot‐scale roll‐to‐roll (R2R) ‐compatible fabrication of flexible perovskite solar modules. Thiol vapor selectively regulates crystallization and anchors at grain boundaries, reducing defects while enhancing mechanical resilience.
Lirong Dong   +18 more
wiley   +2 more sources

Small-Angle Neutron Scattering on Grain Boundaries of Cold-Rolled Nickel. [PDF]

open access: yesMaterials (Basel)
Li T   +10 more
europepmc   +1 more source

Circularly Polarized Luminescent and Melt‐Processable Copper(I)‐Organic Glasses Based on 2,2′‐Bis(diphenylphosphino)‐1,1′‐binaphthyl

open access: yesAngewandte Chemie, EarlyView.
Homochiral Cu(I) cyanide complexes based on 2,2’‐bis(diphenylphosphino)‐1,1’‐binaphthyl (BINAP) form melt‐quenched and desolvation‐derived metal–organic glasses that exhibit circularly polarized thermally activated delayed fluorescence (TADF) at room temperature, enabling processable chiroptical materials.
Zeyu Fan   +5 more
wiley   +2 more sources

Electroplastic Cyclic Deformation of CuZn30 Brass. [PDF]

open access: yesMaterials (Basel)
Weiler W, Jaśkiewicz K, Zimniak Z.
europepmc   +1 more source

Numerical modelling of the aluminium extrusion process when producing complex seactions.

open access: yes
This thesis reports the analysis by FEM of both continuum and structural models describing the extrusion process. They were compared with experimental work and the agreement is satisfactory.
Longjang, Niu
core  

Numerical modelling of the aluminium extrusion process and comparison with results obtained from industrially extruded complex sections.

open access: yes
This thesis reports the analysis of extruded products by Forge2009® and EBSD produced by the investigator in the BOAL plant. The 3D FEM module was used to study the required load, the temperature evolution, surface formation of the extrudate and material
Nilsen, Kjell Einar
core  

Home - About - Disclaimer - Privacy