Results 231 to 240 of about 1,041,897 (290)

Paper 14: Developments in Refractory Castables

open access: yesProceedings of the Institution of Mechanical Engineers, Conference Proceedings, 1965
A short account, not intended for specialists, is presented of the constitution and general properties of refractory castable mixes. The basic factors affecting the performance of castable refractories are discussed and modern trends in the compounding of the mixes, and in the manufacture of the cement bond, are outlined. Attention is drawn to certain
T. D. Robson
openaire   +2 more sources

Carbonation of Alumina Cement-bonded Conventional Refractory Castable in Fireplace

open access: yesMaterials Science, 2006
It was determined by verification by in situ analysis that combustion products of firewood in fireplaces causecarbonation of alumina cement-bonded conventional refractory castable and accelerate its destruction.
S. Goberis, R. Stonys
semanticscholar   +2 more sources

Effect of Y2O3 additions on low cement high alumina refractory castable

Ironmaking & Steelmaking, 2023
The effect of adding yttria (Y2O3) up to 2 wt.% on low cement high alumina castable is studied. Castable compositions with self-flowing and vibratable consistency (distribution coefficients, q = 0.21 and 0.29) are prepared using commercial raw materials ...
Satyam Kumar   +2 more
semanticscholar   +1 more source

Development of Aluminium Oxychloride Bonded Fused Magnesia Based Basic Refractory Castable

Transactions of the Indian Ceramic Society, 2014
B. K. Sanfui, T. K. Parya
exaly   +2 more sources

The influence of surface-modified graphites on the rheological pattern of alumina-carbon cementitious refractory castable matrix

Ceramics International, 2019
The present contribution focused mainly on the fundamental understanding of the influence of surface-modified graphite on rheology of the matrix of a castable slurry in comparison to the same containing the uncoated one.
S. Mukhopadhyay
semanticscholar   +1 more source

Nano-bonded refractory castables

Ceramics International, 2013
Abstract Calcium aluminate cement (CAC) contents higher than 3 wt% in refractory castables can have some drawbacks in the various processing steps (mainly drying) and also in their refractoriness when in contact with SiO 2 . The use of colloidal silica as an alternative binder has been studied by many researchers in recent years and recently reports ...
M. Nouri-Khezrabad   +4 more
openaire   +1 more source

Correlation of damage after first cycle with overall fatigue resistance of refractory castable concrete

Construction and Building Materials, 2019
Cyclic thermal loads experienced in service by castable refractory concrete often cause fatigue failure. Displacement controlled cyclic fatigue measurements were performed on samples of corundum-andalusite refractory concrete at room temperature and at ...
K. Andreev   +4 more
semanticscholar   +1 more source

Development of waste derived nano-lakargiite bonded high alumina refractory castable for high temperature applications

Ceramics International, 2019
This work provides a new binder system, i.e., nano-lakargiite (NL) [CaZrO3] for unshaped refractories. NL powder formulation is done through a green and facile route, i.e., solution mixing technique, which is easily capable of recycling the byproducts ...
S. Hossain, P. Roy
semanticscholar   +1 more source

Castable Refractories Based on Zircon

Transactions of the Indian Ceramic Society, 1971
Castables based on zircon sand were made and their physical properties were determined after various heat treatments. It was found that zircon sand can be used as an aggregate material in castables with good results.
J. C. Banerjee, K. Ramesam, A. Salim
openaire   +1 more source

Home - About - Disclaimer - Privacy