Results 61 to 70 of about 123,760 (314)
Атеросклероз, 2016 This article is devoted to discussion about main aspects of current use of non-statin hypolipidemic drugs according last international guidelines (including fibrates, nicotinic acid, resins, polyunsaturated fatty acids, ezetimibe, PCSK9-inhibitors).
A. E. Bagriy +6 more
doaj
Arthritis Care &Research, EarlyView.Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
Bio-Based Epoxy Resins Derived From Eugenol With Low Dielectric Constant
, 2017 In this paper, a series of bio-based epoxy resins containing organic silicone were prepared from eugenol through a mild synthetic route. Then, 4,4'-diaminophenyl methane (DDM) was applied to cure these epoxy resins, and bisphenol A epoxy resin (DGEBA ...
Zhu, Jin +15 more
core +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Effect of solubilization technique on dissolution
Journal of Applied Pharmaceutical Research, 2014 More than 40 percent of newly discovered drugs have little or no water solubility thus the present research aimed at the study of improvement of solublisation on dissolution by addition of different solublising agents and modification of methods ...
Sujoy Das +3 more
doaj
High Voltage, 2019 High power density generators and motors are envisaged in modern all-electric ships where electrical power for both propulsion and service loads is provided through a common electrical platform known as an integrated power system. Three recent high-power
Mona Ghassemi
doaj +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Micro-slurry jet for surface processing of dental ceramics
Biosurface and Biotribology, 2019 A micro-slurry jet (MSJ) was used for removing microscopic cracks and microstructural defects on surfaces of dental ceramics, in which the MSJ functioned as a wet blasting machine using mixed alumina particles and water to spray workpiece surfaces by a ...
Takashi Baba +5 more
doaj +1 more source
Recovery of gold from thiosulfate solutions and pulps with anion-exchange resins
, 2002 With growing environmental and occupational safety concerns over the use of cyanide in gold processing, more acceptable alternatives are receiving increased interest. The most promising of the possible alternatives is thiosulfate.
O'Malley, Glen Peter
core
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source