Results 121 to 130 of about 389,332 (208)
Optimized ITO back contact with pre‐Ga supply growth and Ag incorporation suppresses GaOx formation and interface recombination in bifacial CIGS solar cells. The devices achieve 17.25% front and 5.77% rear efficiency, delivering record bifacial power density up to 32.26 mW cm−2 in 4T perovskite/CIGS tandem architectures under enhanced albedo ...
Amanat Ali +13 more
wiley +1 more source
An innovative custom-designed inductively coupled plasma-assisted RF magnetron sputtering deposition system has been developed to synthesize B-doped microcrystalline silicon thin films using a pure boron sputtering target in a reactive silane and argon ...
Ostrikov, K. +3 more
core +1 more source
Iron oxide nanomaterials are promising candidates for various electrochemical applications. However, under operating conditions high electric resistance is still limiting performance and lifetime.
Fee Käufer +3 more
doaj +1 more source
Structural Defects and Ferromagnetic Signature of V-Doped Sb2Te3 Thin Films Grown on SrTiO3(001) Produced by RF-Magnetron Sputtering. [PDF]
Sato K.
europepmc +1 more source
This work reveals a “Photovoltaic‐Capacitance” coupling mechanism in stacked Ga2O3/ZnO devices, defining the ZnO/graphene interface as a novel Photovoltaic Dynamic‐Capacitor (PDC). The wavelength‐selective bipolar response enables a physical layer secure communication protocol based on ternary optical logic (“1,” “0,” “−1”).
Songqi Zhao +6 more
wiley +1 more source
Radio-frequency (RF) magnetron sputtering
On-line training for the use of experimental equipment: Radio-frequency (RF) magnetron sputtering. Magnetron sputtering is an extremely flexible coating technique that can be used to coat virtually any material.
Dr Nicola Morley, The University of Sheffield
core
Electrical and Optical Properties of ZnO:Al Film prepared on Polyethersulfone Substrate by RF Magnetron Sputtering [PDF]
[[abstract]]This study investigates the process parameter effects on the electrical and optical properties of AZO (ZnO:Al) thin film using radio frequency (RF) magnetron sputtering on flexible PES (polyethersulfone) substrates.
Chen, M. Z. ; Lin, Yi- Cheng; Kuo, C. C. +1 more
core
Hardware and power management for high power impulse magnetron sputtering
The work that led to the development of the HiPIMS technique was initiated at the Moscow Engineering and Physics Institute (MEPhI) in the late 1960s, where high power pulses were applied to diode sputter sources.
Zdeněk Hubička +7 more
core +1 more source
A simple two-step approach was proposed to obtain hBN thin films with high crystalline quality, meaning that the films were initially prepared by using an RF magnetron sputtering technique and subsequently followed by a post-annealing process at a high ...
Qiang Li +9 more
doaj +1 more source
Reset First Resistive Switching in Ni1-xO Thin Films as Charge Transfer Insulator Deposited by Reactive RF Magnetron Sputtering. [PDF]
Kim DW, Kim TH, Kim JY, Sohn HC.
europepmc +1 more source

