Results 151 to 160 of about 4,438 (211)

A Wide-Bandwidth Inexpensive Current Sensor Based on the Signal Fusion of Tunneling Magnetoresistance and a Current Transformer. [PDF]

Sensors (Basel)
Wang K, Li B, Wang L, Wang J, Li C, Ding Z, Shao H.   +6 more
europepmc   +1 more source

Design and Simulation of Magnetic Shielding Structure Based on Closed-Loop TMR Current Sensor. [PDF]

Micromachines (Basel)
Li Q, Xiong S, Wang S, Dong X, Zhang H.
europepmc   +1 more source

Dynamics of plasma reconfiguration after pellet injection in Heliotron J. [PDF]

Sci Rep
Ogihara K, Inagaki S, Kado S, Matsutani R, Motojima G, Kobayashi S, Kin F, Ohshima S, Minami T, Konoshima S, Mizuuchi T, Okada H, Nagasaki K.   +12 more
europepmc   +1 more source

Signal versus current (Rogowski coil)

, 2018
openaire   +1 more source

A Micro Bridge-Wing-Thickened Low-Energy Exploding Foil Initiator Chip. [PDF]

Micromachines (Basel)
Xue P, Hu H, Wang T, Xiong P, Li M, Zeng Q.   +5 more
europepmc   +1 more source

Design and Validation of Miniaturized Repetitive Transcranial Magnetic Stimulation (rTMS) Head Coils. [PDF]

Sensors (Basel)
Abbasi S, Alluri S, Leung V, Asbeck P, Makale MT.   +4 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Machinable Rogowski coil, design, and calibration

IEEE Transactions on Instrumentation and Measurement, 1996
Rogowski coils are special types of mutual inductors often used to measure high AC and transient currents. Traditional designs are reviewed. The significant sources of error associated with typical coil designs are examined. A "machinable Rogowski coil" is introduced and discussed. The reasoning behind critical design choices is discussed. The improved
openaire   +3 more sources

Digital Compensation of Rogowski Coil's Output Voltage

IEEE Transactions on Instrumentation and Measurement, 2013
Due to inherent characteristics of Rogowski coils, measured signals by these transducers are distorted, and hence, it is a need to compensate their output voltages in order to reconstruct their input current. Using analog circuits for the reconstruction of the input current of a Rogowski coil is a very common technique, but this technique has no ...
Esmaeil Hemmati, S. Mohammad Shahrtash
openaire   +3 more sources

MEMS Rogowski coil current sensor with spiral return coil

Electrical Engineering in Japan, 2022
AbstractWe have developed a MEMS Rogowski coil current sensor with spiral return coil. The Rogowski coil is formed on a silicon substrate clockwise and counterclockwise from the edges, for current detection and external magnetic noise compensation (device size 10 × 10 × 0.3 mm3, spiral coil 135 turns, via diameter 100 μm).
Yoshiyuki Watanabe, Mutsuto Kato, Toru Yahagi, Hiroki Murayama, Naoya Yamada, Kenichi Yoshida, Kenichi Maehara, Yusuke Fukuda, Kazuyuki Sashida, Katsuya Ikeda, Kosuke Ikeda, Toshiyuki Takemori   +11 more
openaire   +1 more source

Linear Rogowski coil

Review of Scientific Instruments, 2017
Nowadays, the employment and development of fast current pulses require sophisticated systems to perform measurements. Rogowski coils are used to diagnose cylindrical shaped beams; therefore, they are designed and built with a toroidal structure. Recently, to perform experiments of radiofrequency biophysical stresses, flat transmission lines have been ...
V. Nassisi, D. Delle Side
openaire   +2 more sources