The Rolling Shear Influence on the Out-of-Plane Behavior of CLT Panels: A Comparative Analysis
Buildings, 2020 This paper deals with the influence of the rolling shear deformation on the flexural behavior of CLT (Cross-Laminated Timber) panels. The morphological configuration of the panels, which consist of orthogonal overlapped layers of boards, led to a ...
Bruno Calderoni
exaly +3 more sources
Rolling Shear Strength of Cross Laminated Timber (CLT)—Testing, Evaluation, and Design
Buildings, 2023 Cross laminated timber (CLT), with its typical orthogonal layering and exposure to out-of-plane bending, develops inherent rolling shear stresses. These stresses need to be checked during the ultimate limit state design process. With the ongoing revision
David Glasner +3 more
doaj +1 more source
Experimental and theoretical study on minimum achievable foil thickness during asymmetric rolling. [PDF]
PLoS ONE, 2014 Parts produced by microforming are becoming ever smaller. Similarly, the foils required in micro-machines are becoming ever thinner. The asymmetric rolling technique is capable of producing foils that are thinner than those produced by the conventional ...
Delin Tang +3 more
doaj +1 more source
Forces in Mechanics, 2022 The objective of this investigation is to evaluate the cyclic plastic deformation response at the subsurface during rolling contact fatigue (RCF) under the conditions of pure rolling and rolling-sliding.
Surajit Kumar Paul +2 more
doaj +1 more source
Characterization of Plastic Deformation in CuZr Metallic Glasses Subjected to the Rolling Process
Advances in Materials Science and Engineering, 2023 Using the rolling process, it is possible to induce multiple shear bands in the microstructure of metallic glasses (MGs) and improve the overall plasticity in the subsequent mechanical loadings.
Ramaswamy Sivaraman +4 more
doaj +1 more source
A study on the effect of grain morphology on shear strength in granular materials [PDF]
EPJ Web of Conferences, 2021 The Discrete Element Method (DEM) has been successfully used to further understand GM behaviour where experimental means are not possible or limited. However, the vast majority of DEM publications use simplified spheres with rolling friction to account ...
Govender Nicolin, Pizette Patrick
doaj +1 more source
Texture, Microstructure and Mechanical Properties of 6111 Aluminum Alloy Subject to Rolling Deformation [PDF]
Materials Research, 2017 The mechanical properties, texture and microstructural evolution of a 6111 aluminum alloy during hot rolling and cold rolling deformation were systematically investigated in this article.
Lixin Zhang +6 more
doaj +1 more source
Recrystallization Behavior of Warm Rolling and Cold Rolling Cr-Ti-B Steel during Annealing
Metals, 2022 To study the nucleation and recrystallization behavior of deformation bands, shear bands and grain boundaries during the recrystallization process, a heat treatment test was carried out on Cr-Ti-B low-carbon steel after warm rolling and cold rolling. The
Ankang Huang +6 more
doaj +1 more source
Anisotropic micro cutting of rolled titanium alloy
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2023 In machining of rolled titanium alloy, the anisotropy in the cutting force induced by the rolling texture should be controlled to achieve high quality surface.
Shoichi TAMURA +3 more
doaj +1 more source
Shear strength properties of hybrid (hinoki cypress and Japanese cedar) cross-laminated timber
Journal of Wood Science, 2021 In this study, the out-of-plane shear strength of hybrid cross-laminated timber (CLT) with outer layers of hinoki (hinoki cypress, Chamaecyparis obtusa) and inner layers of sugi (Japanese cedar, Cryptomeria japonica) is investigated for four different ...
Seiichiro Ukyo +3 more
doaj +1 more source