Results 21 to 30 of about 754,039 (282)
Interfacial microstructure and shear strength of Ti-6Al-4V/TiAl laminate composite sheet fabricated by hot packed rolling [PDF]
, 2011 A two layer Ti-6Al-4V(wt%)/Ti-43Al-9V-Y(at%) laminate composite sheet with a uniform interfacial microstructure and no discernible defects at the interfaces has been prepared by hot-pack rolling, and its interfacial microstructure and shear strength were
Chen, Yuyong +5 more
core +1 more source
Metals, 2022 Rolling is one of the most employed industrial processes which can be used at multiple manufacturing stages, allowing different geometries such as plates, rods, profiles, billets, slabs, tubes, and seamless tubes to be obtained.
Jairo Alberto Muñoz +5 more
doaj +1 more source
Simulation of oxide scale failure during multipass hot rolling and related product defects [PDF]
Computer Methods in Materials Science, 2005 The advanced physically based finite element model of the roll-stock interface developed at earlier stages of the research for a single rolling pass has been extended to provide the basis for detailed numerical investigations of the roll/stock interface ...
Michał Krzyżanowski, J.H. Beynon
doaj +1 more source
Rolling shear strength of timber boards
Bulletin of Kharkov National Automobile and Highway University, 2020 Abstract. Problem Rolling shear strength and rolling shear modulus are important mechanical and elastic properties that have emerged recently and are needed when calculating multi-storey CLT buildings. Goal Rolling shear is a new task that requires determining the influencing factors on it’s magnitude as an indicator of the strength of the boards in ...
Bidakov, Andrii +3 more
openaire +3 more sources
The Influence of Panel Lay-Up on the Characteristic Bending and Rolling Shear Strength of CLT
Buildings, 2018 The objective of this study was to characterise the behaviour of cross laminated timber (CLT) panels and the influence of the panel lay-up on the failure strength.
Conan O’Ceallaigh +2 more
doaj +1 more source
MATEC Web of Conferences, 2017 A three-roll rolling process is a significant technique in the production of wire rod, round bars and hexagonal profiles for structural applications. Better mechanical properties of wire rod, round bars and hexagonal profiles can be achieved due to large
Pesin Alexander +3 more
doaj +1 more source
A fast calculation method of large-cylinder asymmetrical rolling force considering shear effect
Advances in Mechanical Engineering, 2019 An analytical model for large-cylinder asymmetrical rolling is proposed based on an improved slab method, which can predict the rolling force more quickly. In this method, uneven normal and shear stresses acting on the vertical side are supposed.
Suwen Chen +4 more
doaj +1 more source
Metals, 2023 To solve the edge crack problem of AZ31B magnesium alloy cold rolling, a strong pulsed electric current was introduced to the cold rolling process. The influence of intensity, frequency, width of pulsed electric current and other parameters on edge ...
Jingna Sun +4 more
doaj +1 more source
Investigating Factors Influencing Rolling Shear Performance of Australian CLT Feedstock
, 2023 Investigating Factors Influencing Rolling Shear Performance of Australian CLT ...
Mahbube Subhani (13096398)
core
Rolling Shear Modulus of Sweetgum Plywood and Unidirectionally Laminated Veneer [PDF]
, 2007 Experimentally obtained values of apparent rolling shear modulus and strength of sweetgum 4-ply, 12.7-mm-thick plywood, when the shear forces are applied parallel to the face grain of the plywood, are presented.
Biblis, Evangelos J.
core +1 more source