Results 11 to 20 of about 337,376 (283)
Vibration analysis of compressor blade tip-rubbing [PDF]
, 2011 There has been a significant increase in air traffic volume, particularly over the past twenty years. In order to cope with this increase in demand, it has been necessary to increase the efficiency of aircraft engines.
Arzina, Dina
core +7 more sources
Experimental Testing of Tip-Timing Methods used for Blade Vibration Measurement in the Aero-Engine [PDF]
, 2004 An important component within the jet engine in terms of vibration and high cycle fatigue (HCF) is the blade. This is the component where continuously higher demands on weight and loading are being made.
Grant, Kelly
core +7 more sources
Capacitance Tip Timing Techniques in Gas Turbines [PDF]
, 2003 The vibration of turbomachinery blades is an important phenomenon to understand, observe and predict and is the reason for developing a tip timing measurement system.
Lawson, Craig P.
core +7 more sources
CNN-based defect diagnosis method for rotating blades
You-qi chuyun, 2020 In order to solve the problem of difficult blade defect diagnosis caused by severe signal under-sampling in tiptiming technology, a defect diagnosis method for rotating blade based on convolution neural network (CNN) was proposed.In the method, the under-
Jiwang ZHANG +3 more
doaj +1 more source
PLoS ONE, 2021 In recent years, the flow characteristics research of the interstage region in counter-rotating axial fans in terms of fluid dynamics has attracted much attention.
Xinzhe Zhang +4 more
doaj +1 more source
Local Heat Transfer Measurements on a Rotating Flat Blade Model with a Single Film Hole [PDF]
, 2009 An experimental study was performed to measure the heat transfer coefficient distributions on a flat blade model under rotating operating conditions. A steady-state thermochromic liquid crystal technique was employed to measure the surface temperature ...
Tao, Zhi +8 more
core +1 more source
Influence of design parameters on the global performances of low-speed counter-rotating axial-flow fans [PDF]
, 2014 The present work aims at experimentally investigating the effects of some parameters on the performances of a counter-rotating stage, and on the instationary flow between the rotors.
BAKIR, Farid +5 more
core +1 more source
On The Vibration of a Cracked Rotating Blade [PDF]
Shock and Vibration, 1998 The dynamic behavior of a rotating blade containing a transverse crack was investigated. First, the local flexibility of the cracked blade was obtained by using the method of the released energy. An energy principle, in conjunction with a weighted residual method, was then applied to yield the discrete equations of motion.
Ming-Chuan Wu, Shyh-Chin Huang
openaire +2 more sources
Analysis of Cavitation Instabilities in a Four-Blade Inducer [PDF]
, 2012 The cavitating behavior of a four-blade inducer tested in the LML laboratory large test facility is considered in the present paper. Experimental investigations based on unsteady pressure measurements and records from a six-component balance mounted on ...
DAZIN, Antoine +7 more
core +1 more source
Hangkong gongcheng jinzhan, 2018 It is of important significance to study the vibration characteristics and vibration suppression technology of aero-engine rotating blades to improve the engine performance, structural integrity and working reliability.
Qin Jie, Yan Qun, Huang Wenchao
doaj +1 more source