Results 141 to 150 of about 641,720 (293)
Jian Li +4 more
openaire +1 more source
The initial imperfections in bolted end-plate connections are mainly induced by residual deformation from welding. Three typical initial imperfections, namely V-shape, Cshape, and W-shape have been identified based on field studies in the literature ...
Dharmawansha, S, Herath, S
core
Soft dielectric elastomer composites often face a trade‐off between enhanced dielectric properties and mechanical compliance. Here, a parallel‐aligned polyurethane nanofiber network embedded in PDMS creates a flexible, durable composite with increased permittivity, low modulus, and fatigue stability after 100,000 cycles.
Yi Ge +9 more
wiley +1 more source
Stiffness in human joints [PDF]
Articular stiffness is an important symptom in most arthritic diseases and appears to be a useful marker of disease activity in rheumatoid arthritis.
Helliwell, Philip Stephen
core
Extrusion‐Based Bioprinting of Living Bioinks for Tissue and Organ Engineering
Extrusion‐based bioprinting is presented as the most versatile route for fabricating living, heterogeneous tissues. Its ability to combine diverse bioinks, support matrices, and advanced printhead geometries transforms familiar constraints into powerful biofabrication opportunities.
Eric Silberman +4 more
wiley +1 more source
Deflection analysis of sleeve jointed purlin systems with non-linear rotational stiffness
Sleeved purlin systems are usually used in roof constructions. A non-linear relationship between the bolt hole extension and the load transferred to the bolt was derived with experimental testing and numerical simulation.
Chang J Wang (16155056) +3 more
core
Red‐Light Tomographic Volumetric 3D Printing in Seconds for Fabrication of Colorless Structures
A custom red‐light‐responsive TVAM platform combines methylene blue, triethanolamine, and PEGDA to fabricate transparent crosslinked hydrogels. Light patterns are projected into a rotating resin container, where a sacrificial photoinitiator system enables rapid polymerization and colorless channel‐containing structures, utilizing low‐energy light for ...
Ali Eftekhari +9 more
wiley +1 more source
Jian Li +5 more
openaire +2 more sources
Nanoimprint lithography can replicate complex 3D microstructures with undercuts using single‐layer polymer stamps of different elasticities. By combining experiments and simulations, T‐shaped geometries and suitable undercut radii were identified that minimize stress and defects during demolding.
Christos Julianos Karapatzakis +3 more
wiley +1 more source
Microfabrication using nano‐ to micron‐sized blocks has transformative potential for next‐gen electronics, optoelectronics, and materials. Traditional methods are limited by scalability and precision. STIC, a single‐laser system for precise colloid manipulation and immobilization using femtosecond lasers, is introduced that enables efficient 3D ...
Krishangi Krishna +4 more
wiley +1 more source

