Results 31 to 40 of about 131,284 (306)
A novel permanent magnet flux switching machine with an outer-rotor configuration for in-wheel light traction applications [PDF]
This paper proposes a novel permanent magnet flux switching (PMFS) machine with an outer-rotor configuration for in-wheel light traction applications.
Shen, Jian-Xin +4 more
core +1 more source
The stator of the stepped rotor type bearingless switched reluctance motor has two kinds of wide and narrow stator teeth. The wide stator teeth provide suspension force, and the narrow stator teeth provide torque, so the decoupling control of torque and ...
Zhenyao Xu +4 more
doaj +1 more source
A Novel Evaluation Method for Vibration Coupling of Complex Rotor–Stator Systems in Aeroengines
With the increase in thrust–weight ratio of advanced aeroengines, the rotor and stator often exhibit comparable stiffness characteristics, leading to significant vibration coupling which harms the safety and reliability of operations.
Yongbo Ma +5 more
doaj +1 more source
In view of problems of technical difficulties, high cost and high voltage requirements for power electronic components in current high voltage wound-rotor motor using stator-side high voltage inverter for frequency conversion speed regulation, a rotor ...
CHENG Guodong +2 more
doaj +1 more source
Impulsive Control of the Rotor-Stator Rub Based on Phase Characteristic
An impulsive control method is proposed to eliminate the rotor-stator rubbing based on the phase characteristic. The relation between the vibration energy and the phase difference suggests the starting point for controlling the rotor-stator rubbing by ...
Jieqiong Xu, Qunhong Li, Shimin Wang
doaj +1 more source
Bispectrum of stator phase current for fault detection of induction motor
A number of research studies has shown that faults in a stator or rotor generally show sideband frequencies around the mains frequency (50 Hz) and at higher harmonics in the spectrum of the Motor Current Signature Analysis (MCSA).
Gu, Fengshou +5 more
core +1 more source
Phase Field Failure Modeling: Brittle‐Ductile Dual‐Phase Microstructures under Compressive Loading
The approach by Amor and the approach by Miehe and Zhang for asymmetric damage behavior in the phase field method for fracture are compared regarding their fitness for microcrack‐based failure modeling. The comparison is performed for the case of a dual‐phase microstructure with a brittle and a ductile constituent.
Jakob Huber, Jan Torgersen, Ewald Werner
wiley +1 more source
Fluid mixing in rotor/stator mixers [PDF]
An industrial rotor-stator mixer was fitted into a flow loop to carry out overall power balance, flow visualisation and residence time distribution experiments. These were performed on various rotor-stator geometries and a half-scale unit. The overall
Sparks, T.
core
Core Losses and Torque Ripple in IPM Machines: Dedicated Modeling and Design Trade Off [PDF]
The proper combination of stator and rotor slot numbers is pursued in the design of interior permanent-magnet (IPM) motors with wide constant-power speed range.
P. Guglielmi +12 more
core +1 more source
Design Theory of Stator and Rotor of PDM Based on Rack Gearing Principle
The stator and rotor contour designed by the traditional line pattern design method is not smooth at the joint of the cycloidal arc and the arc, where the stator rubber is continuously worn during operation, which will accelerate the damage of the rubber
Yao Yang
doaj

