Results 61 to 70 of about 38,616 (285)
Review on the aerodynamics of intermediate compressor duct
In a turbofan engine, the air is brought from the low to the high-pressure compressor through an intermediate compressor duct. Weight and design space limitations impel to its design as an S-shaped.
Manish Sharma, Beena D. Baloni
doaj +1 more source
ABSTRACT Background and Purpose White matter hyperintensities (WMH) are a core neuroimaging marker of cerebral small vessel disease (CSVD). Sleep apnoea (SA) is a recognized vascular risk factor, but its associations with regional WMH burden, short‐interval WMH change and cognitive performance in population‐based cohorts remain incompletely defined. We
Peng Cheng +4 more
wiley +1 more source
Early Clinical, Imaging, and Pathological Characteristics of SRPK3/TTN‐Digenic Myopathy
ABSTRACT Objective SRPK3/TTN‐digenic myopathy was recently established as a skeletal muscle myopathy caused by digenic inheritance. This study characterizes the early clinical presentation of SRPK3/TTN‐digenic myopathy in one previously reported and seven newly identified pediatric patients.
Rotem Orbach +23 more
wiley +1 more source
Experimental Evaluation of Performance Parameters in Air-to-Water Finned-Tube Heat Exchangers Under Variable Inlet Conditions [PDF]
Waste heat recovery (WHR) systems are increasingly recognized for their role in improving energy efficiency and reducing environmental impact across industrial applications. Among various WHR technologies, air-to-water finned-tube heat exchangers (FTHXs)
Ahmad Takash +5 more
doaj +1 more source
Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
A New Approach to Designing the S-Shaped Annular Duct for Industrial Centrifugal Compressor
The authors propose an analytical method for designing the inlet annular duct for an industrial centrifugal compressor using high-order Bezier curves. Using the design of experiments (DOE) theory, the three-level full factorial design was developed for ...
Ivan Yurko, German Bondarenko
doaj +1 more source
Objective To investigate the association between rheumatoid arthritis (RA) and coronary artery calcium (CAC) prevalence, incidence, and progression over four years in adults without prior cardiovascular disease. Methods A case‐cohort study within the Brazilian Longitudinal Study of Adult Health (ELSA‐Brasil) included 585 participants (86 patients with ...
Patrícia Fonseca Estrada +7 more
wiley +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Sand transport in northern Venice Lagoon through the tidal inlet of Lido [PDF]
The provenance and transport of sand has been investigated around Lido Inlet, the largest ofthree tidal inlets in Venice Lagoon, Italy. Morphological analysis has established the presenceof an ebb-tidal delta extending from the mouth of Lido Inlet as ...
Helsby, Rachel
core
Pulsating flow and convective heat transfer in a cavity with inlet and outlet sections
This paper deals with the study of 2-D, laminar, pulsating flow inside a heated rectangular cavity with different aspect ratios. The cooling liquid (water with temperature dependent viscosity and thermal conductivity) comes and leaves the cavity via ...
Velázquez, A. +2 more
core +1 more source

