Results 131 to 140 of about 503,414 (282)

MORPHOLOGICAL CHARACTERS STUDY FOR ELEVEN SPECIES BELONGS TO BRASSICACEAE FAMILY IN IRAQ

The Iraqi Journal of Agricultural science
This study was amied to investigate morphological  characteristics of pollen grains  and fruits for eleven species belonging to the tribe Brassiceae of cruciferae family, species are: Brassica rapa L , Braasica deflexa Boiss.
Marwa. K. Mathree, S. A. Aliwy
doaj  

Examination of exfoliated cervical cells by the scanning electron microscope (SEM) [PDF]

British Journal of Cancer, 1973
J M Allen, J A Jordan, J F Murphy, A E Williams   +3 more
openaire   +2 more sources

Near‐Infrared Emitting Lanthanide Catecholate Giant Single Crystals – Morphology Control and Photon Down‐Conversion

Advanced Functional Materials, EarlyView.
Controlled syntheses of lanthanide coordination polymers based on the dihydroxybenzoquinone (DHBQ) organic linker afforded large single crystals of Ln‐DHBQ CPs (Ln = Yb, Nd). A novel structural variant of Yb‐DHBQ is identified by means of single crystal diffraction analysis.
Marina I. Schönherr, Alexander Biewald, Andre Mähringer, Thaddäus J. Koller, Peter Mayer, Markus Döblinger, Achim Hartschuh, Dana D. Medina   +7 more
wiley   +1 more source

Photocatalytic Versus Stoichiometric Hydrogen Generation Using Mesoporous Silicon Catalysts: The Complex Role of Sacrificial Reagents

Advanced Functional Materials, EarlyView.
This study highlights the importance of accounting for stoichiometric hydrogen produced when utilizing Si photocatalysts. The stoichiometric contribution is sacrificial reagent dependent and decreases with increasing sterics around the catalyst surface.
Sarrah H. Putwa, Sarah A. Martell, Berthold Reis, Simona Schwarz, Mita Dasog   +4 more
wiley   +1 more source

Defect Analysis of the β– to γ–Ga2O3 Phase Transition

Advanced Functional Materials, EarlyView.
The role of defects at all the relevant stages of the β$\beta$‐ to γ$\gamma$‐Ga2O3 polymorph transition is investigated using a multi method approach. The positron annihilation spectroscopy based results show that the defect density decreases after the transition, and that changes in defect configuration within the γ phase occur with increasing ...
Umutcan Bektas, Maciej O. Liedke, Huan Liu, Fabian Ganss, Maik Butterling, Nico Klingner, René Hübner, Ilja Makkonen, Andreas Wagner, Gregor Hlawacek   +9 more
wiley   +1 more source

Composites of Shellac and Silver Nanowires as Flexible, Biobased, and Corrosion‐Resistant Transparent Conductive Electrodes

Advanced Functional Materials, EarlyView.
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein, Tiago Carneiro Gomes, Eliza Ng, Simon Rondeau‐Gagné, Tricia Breen Carmichael   +4 more
wiley   +1 more source

In Situ Study on Fracture Behavior of Z-Pinned Carbon Fiber-Reinforced Aluminum Matrix Composite via Scanning Electron Microscope (SEM). [PDF]

Materials (Basel), 2019
Zhang Y, Wang S, Zhao X, Wang F, Wu G.
europepmc   +1 more source

CRISPR/Cas9‐Assisted Microrobots for Fast and Ultrasensitive “On‐The‐Fly” Next‐Generation DNA Detection

Advanced Functional Materials, EarlyView.
This work presents self‐propelled CRISPR/Cas9‐functionalized Au–MRs for rapid, amplification‐free, “on‐the‐fly” DNA detection. By harnessing motion‐assisted signal recovery, the platform achieved the limit of detection in low fM DNA concentrations, enabling detection across a wide dynamic range within only 5 min, which is significantly faster than any ...
Jyoti, Petr Michálek, Zbyněk Heger, Martin Pumera   +3 more
wiley   +1 more source

Scanning Electron Microscope (SEM) Evaluation of the Interface between a Nanostructured Calcium-Incorporated Dental Implant Surface and the Human Bone. [PDF]

Materials (Basel), 2017
Mangano F, Raspanti M, Maghaireh H, Mangano C.   +3 more
europepmc   +1 more source

Positive‐Tone Nanolithography of Antimony Trisulfide with Femtosecond Laser Wet‐Etching

Advanced Functional Materials, EarlyView.
A butyldithiocarbamic acid (BDCA) etchant is used to fabricate various micro‐ and nanoscale structures on amorphous antimony trisulfide (a‐Sb2S3) thin film via femtosecond laser etching. Numerical analysis and experimental results elucidate the patterning mechanism on gold (reflective) and quartz (transmissive) substrates.
Abhrodeep Dey, Uwe Hübner, Albane Benardais, Xiaofei Wu, Andrea Dellith, Jan Dellith, Torsten Wieduwilt, Henrik Schneidewind, Markus A Schmidt, Virginie Nazabal, Volker Deckert, Jer‐Shing Huang, Wei Wang   +12 more
wiley   +1 more source