Results 61 to 70 of about 37,818 (262)

THRESHOLD DETERMINATION FOR LOCAL INSTANTANEOUS SEA SURFACE HEIGHT DERIVATION WITH ICEBRIDGE DATA IN BEAUFORT SEA [PDF]

The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences, 2018
The NASA Operation IceBridge (OIB) mission is the largest program in the Earth’s polar remote sensing science observation project currently, initiated in 2009, which collects airborne remote sensing measurements to bridge the gap between NASA’s ICESat ...
C. Zhu, S. Zhang, F. Xiao, J. Li, L. Yuan, Y. Zhang, T. Zhu   +6 more
doaj   +1 more source

On the Lightweight Potential of Laser Additive Manufactured NiTi Triply Periodic Minimal Sheet Lattices

Advanced Engineering Materials, EarlyView.
This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo, Shuo Qu, Shiming Gao, Xu Song   +3 more
wiley   +1 more source

SEA SURFACE ALTIMETRY BASED ON AIRBORNE GNSS SIGNAL MEASUREMENTS [PDF]

ISPRS Annals of the Photogrammetry, Remote Sensing and Spatial Information Sciences, 2012
In this study the focus is on ocean surface altimetry using the signals transmitted from GNSS (Global Navigation Satellite System) satellites. A low-altitude airborne experiment was recently conducted off the coast of Sydney.
K. Yu, C. Rizos, A. Dempster
doaj   +1 more source

Coupled Pattern Analysis of Sea Surface Temperature and TOPEX/Poseidon Sea Surface Height

Journal of Physical Oceanography, 1999
Abstract Though thermal effects dominate steric changes in sea level, the long-period contribution of thermal expansion to sea level is uncertain. Nerem et al. found that a global map of sea surface temperature (SST) trends and a corresponding map of TOPEX/Poseidon-derived sea surface height (SSH) trends were strongly correlated.
Eric W. Leuliette, John M. Wahr
openaire   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Impact of Ross Gyre on surface circulation in the Amundsen Sea, Antarctica

Environmental Research Communications
The east limb of the Ross Gyre approaches the western Amundsen Sea, thereby exerting an influence on the surface circulation dynamics. This study investigates the impact of the zonal movement of the eastern boundary of the Ross Gyre on the surrounding ...
Hailun He
doaj   +1 more source

Surface roughness signatures of summer arctic snow-covered sea ice in X-band dual-polarimetric SAR

GIScience & Remote Sensing, 2020
Surface roughness of sea ice is primary information for understanding sea ice dynamics and air–ice–ocean interactions. Synthetic aperture radar (SAR) is a powerful tool for investigating sea ice surface roughness owing to the high sensitivity of its ...
Hyangsun Han, Jae-In Kim, Chang-Uk Hyun, Seung Hee Kim, Jeong-Won Park, Young-Joo Kwon, Sungjae Lee, Sanggyun Lee, Hyun-Cheol Kim   +8 more
doaj   +1 more source

Determining Variability in Arctic Sea Ice Pressure Ridge Topography With ICESat‐2

Geophysical Research Letters, 2022
We investigate the characteristics and distribution of pressure ridges in Arctic sea ice using a novel algorithm applied to ICESat‐2 surface heights. We derive the frequency and height of individual pressure ridges and map surface roughness and ridging ...
K. Duncan, S. L. Farrell
doaj   +1 more source

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

Advanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky, Marcelo Sallese, Leander Kläber, Clemens Kuhn, Keming Du, Andrés Fabián Lasagni   +5 more
wiley   +1 more source

Variable Stiffness Flexure Structures Enabled by Phase‐Change Gallium and Adhesive Interfacial Locking for Soft Robotic Applications

Advanced Engineering Materials, EarlyView.
A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim, Sohee John Yoon, Yong‐Lae Park   +2 more
wiley   +1 more source