Results 181 to 190 of about 97,166 (237)

Numerical Investigation of a Dual‐Mode Shape Memory Alloy Stent Enabling Secondary Expansion via Focused Ultrasound: A Potential Strategy for Correcting In‐Stent Restenosis

open access: yesAdvanced Engineering Materials, EarlyView.
This study demonstrates a novel noninvasive strategy to treat in‐stent restenosis using focused ultrasound. A shape memory alloy stent initially expands at body temperature. If restenosis occurs, targeted ultrasound heating thermally actuates the stent, enabling a secondary expansion to reopen the blocked vessel, offering a potential alternative to ...
Stephen Asare   +3 more
wiley   +1 more source

The Impact of High‐Productivity Processing on the Fatigue Failure of an Additive Manufactured Superalloy HAYNES 282

open access: yesAdvanced Engineering Materials, EarlyView.
The low cycle fatigue life of additive manufactured HAYNES® 282® superalloy was investigated for conventional and high‐productivity processing: samples of the former lasted 1400–1700 cycles, while samples of the latter failed at ~ 1200 cycles, at 760 °C and 1% strain.
Abdul Shaafi Shaikh   +3 more
wiley   +1 more source

Laser Powder Bed Fusion of Copper–Tungsten Composites for Heat Sink Applications in High‐Power Electronics

open access: yesAdvanced Engineering Materials, EarlyView.
This article demonstrates the successful qualification of a copper–tungsten composite for laser powder bed fusion. The resulting components exhibited high density, high thermal conductivity, and reduced thermal expansion. Heat sinks with complex geometries were successfully manufactured, clearly showcasing the material's potential for additive ...
Simon Rauh   +6 more
wiley   +1 more source

Effects of Carbon Nanoparticles on Triboelectro‐Induced Surface Defects

open access: yesAdvanced Engineering Materials, EarlyView.
Carbon nanoparticles added to grease modify the electrocontact behavior. The synergy of particle concentration and electric current dominates the surface damage of metals in contact. Electrical surface damage caused by current leakage is a critical challenge in high‐performance applications such as electric vehicle (EV) drivetrains and wind turbine ...
Mohsen Tajedini   +6 more
wiley   +1 more source

Duplex Stainless Steel Laser‐Surface Textured: Stability in Brine Solution

open access: yesAdvanced Engineering Materials, EarlyView.
Controlled laser‐surface treatment (LST) of duplex DSS2205 steel is performed to increase its stability in brine solution under cyclic electrochemical assays. The superior protection with respect to flat and smooth panels is attributed to the presence of FeCr2O4 as the main protective oxide layer in the LST surface, after corrosion tests. The stability
Mohammad Rezayat   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy