Results 11 to 20 of about 200,245 (303)
Review: Modes and Processes of Severe Plastic Deformation (SPD). [PDF]
Materials (Basel), 2018 In this review, severe plastic deformation (SPD) is considered as a materials processing technology. The deformation mode is the principal characteristic differentiating SPD techniques from common forming operations.
Segal V.
europepmc +2 more sources
A Review of the Most Important Methods for Severe Plastic Deformation of Titanium [PDF]
مواد نوین, 2023 In recent years, extensive studies have been conducted on severe plastic deformation based on suitable processes for sheets and solid materials. Considering the limitations in some properties and crucial applications of titanium metal, these methods are ...
Sayyed Mohammadreza Sedehi +3 more
doaj +1 more source
Impact of severe plastic deformation on kinetics and thermodynamics of hydrogen storage in magnesium and its alloys [PDF]
Journal of Materials Science & Technology, 2022 Magnesium and its alloys are the most investigated materials for solid-state hydrogen storage in the form of metal hydrides, but there are still unresolved problems with the kinetics and thermodynamics of hydrogenation and dehydrogenation of this group ...
K. Edalati +12 more
semanticscholar +1 more source
Metals, 2022 In addition to the micro-topography of machined surfaces, plastic deformation is an important factor affecting the machined surface integrity and the fatigue performance of specimens. For 20Cr and TC17 materials, the effect law of milling surface plastic
Xun Li +4 more
doaj +1 more source
Microstructure evolution during severe plastic deformation [PDF]
Philosophical Magazine, 2011 Radiotracer diffusion studies of severely deformed, ultra-fine grained materials have revealed the presence of ultra-fast transport paths, which include "non-equilibrium" grain boundaries and free volume. Under some experimental conditions, percolating porosity is produced even in pure copper [Ribbe et al., Phys. Rev. Lett. 2009]. Micro-cracks may form
Divinski, Sergiy +2 more
openaire +1 more source
Formation conditions of vortex-like intermixing interfaces in cold spray
Materials & Design, 2021 Experimental investigation was conducted to explore the formation conditions and provide new insights into the formation mechanisms of the unexplained intermixing phenomenon observed at the substrate-coatings interface of cold sprayed materials.
Shuo Yin +8 more
doaj +1 more source
Structural and chemical inhomogeneities in the sintered titanium alloys after severe plastic deformation [PDF]
Металознавство та обробка металів, 2020 The results of studies of porosity, microhardness, microstructure, phase composition, and distribution of alloying elements in samples of VT6 and VT8 titanium alloys are presented.
D.V. Pavlenko
doaj +1 more source
Magnetic dilution by severe plastic deformation
AIP Advances, 2020 Mixtures of Fe and Cu powders are cold-compacted and subsequently deformed with severe plastic deformation by high-pressure torsion, leading to bulk samples.
Martin Stückler +6 more
doaj +1 more source
Tuneable Magneto-Resistance by Severe Plastic Deformation
Metals, 2019 Bulk metallic samples were synthesized from different binary powder mixtures consisting of elemental Cu, Co, and Fe using severe plastic deformation. Small particles of the ferromagnetic phase originate in the conductive Cu phase, either by incomplete ...
Stefan Wurster +6 more
doaj +1 more source
Crystals, 2023 In this study, the influence of the high-pressure torsion (HPT) processing parameters and solution treatment (ST) on the corrosion and tribocorrosion behavior of CoCrMo (CCM) alloys was investigated for possible usage in biomedical applications.
Hakan Yilmazer +7 more
doaj +1 more source