Results 101 to 110 of about 26,617 (308)
Melt Grafting of Geometry‐Tailored Voltage Stabilizers for High‐Performance Polypropylene Insulation
Advanced Functional Materials, EarlyView.A scalable one‐step melt grafting strategy is developed to enhance the dielectric properties of isotactic polypropylene by covalently incorporating thermally stable aromatic voltage stabilizers. This solvent‐free approach improves volume resistivity and DC breakdown strength through deep trap formation and charge localization, offering a sustainable ...
Nazirul Mubin bin Normansah +9 more
wiley +1 more source
Deployable M-braced truss structure [PDF]
, 1986 A deployable M-braced truss structure, efficiently packaged into a compact stowed position and expandable to an operative position at the use site is described.
Mikulas, M. M., Jr., Rhodes, M. D.
core +1 more source
Simulation Studies of Gas-Solid in the Riser of a Circulating Fluidized Bed [PDF]
, 2005 A numerical parametric study was performed on the influence of various riser exit geometries on the hydrodynamics of gas-solid two-phase flow in the riser of a Circulating Fluidized Bed (CFB).
Ani, Farid Nasir +4 more
core +1 more source
Fatigue strength of shear connectors
, 2011 Nowadays steel and concrete composite beams are widely applied in structures mainly subjected to dynamic loads, such as railway and road bridges exposed to traffic loads and industrial crane runways exposed to folk-lift truck loads, the fatigue resistance of these structures must be generally and carefully verified.
Xie, En, Valente, Isabel
openaire +1 more source
Advanced Functional Materials, EarlyView.A vertically stacked, DEA‐driven photonic array inspired by cephalopod skin, featuring highly crystalline colloidal crystal gels with vivid color, low FWHM and scalability is presented. The multilayer design removes lateral pixel interference, achieving near‐100% fill factor with fully independent RGB actuation.
Maga Kim +11 more
wiley +1 more source
BuildingsA precast concrete sandwich panel (PCSP), consisting of inner and outer wythes, an insulation layer, and connectors, relies heavily on the shear behavior of these connectors, which governs the structural performance of the entire system.
Ya Li, Weichen Xue, Jialin Yang
doaj +1 more source
Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting
Advanced Functional Materials, EarlyView.A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar +4 more
wiley +1 more source
Applied Sciences, 2019 In a steel-concrete composite beam (hereafter referred to as a composite beam), partial interaction between the concrete slab and the steel beam results in an appreciable increase in the beam deflections relative to full interaction behavior.
Xinggui Zeng +2 more
doaj +1 more source
Electrical hand tools and techniques: A compilation [PDF]
Space technology utilization for developing tools, adapters, and fixtures and procedures for assembling, installing, and servicing electrical components and equipment are discussed.
core +1 more source
Open tube guideway for high speed air cushioned vehicles [PDF]
, 1974 This invention is a tubular shaped guideway for high-speed air-cushioned supported vehicles. The tubular guideway is split and separated such that the sides of the guideway are open.
Goering, R. S.
core +1 more source