Results 101 to 110 of about 10,318,171 (301)

Shear-Enhanced Transfer Printing of Conducting Polymer Thin Films [PDF]

, 2018
Polymer conductors that are solution-processable provide an opportunity to realize low-cost organic electronics. However, coating sequential layers can be hindered by poor surface wetting or dissolution of underlying layers.
Harald Ade (1273878), Wei You (474340), Ade, H., Pratik Sen, Sungjune Park, Park, S., Zhang, Q., Xiong, Y., Yuan Xiong (40206), Sungjune Park (2104879), Michael W. Kudenov (3960983), Qianqian Zhang, Brendan T. O’Connor (1372707), Sen, P., Brendan T. O’Connor, You, W., Yuan Xiong, OConnor, B.T., Michael W. Kudenov, Wei You, Harald Ade, Pratik Sen (1272978), Qianqian Zhang (587342), Kudenov, M.W.   +23 more
core   +1 more source

Microstructure‑Dependent Phase Transformations Under High‑Pressure Laser Heating in Additively Manufactured AlCrFe2Ni2

Advanced Engineering Materials, EarlyView.
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika, Hunter Kantelis, Yogesh K. Vohra, Shengbiao Zhang, Wuxian Yang, Wen Chen   +5 more
wiley   +1 more source

Flexural performance of composite prefabricated concrete sandwich panels with pultruded square GFRP tubular shear connectors

The flexural performance of composite prefabricated concrete sandwich panels (PCSP) with pultruded square glass fibre-reinforced polymer (GFRP) tubular shear connectors was examined in this study.
Sah, Tilak, Hao, Hong, Manalo, Allan, Chen, Wensu, Lacey, Andrew, Lacey, Andrew William, Sah, Tilak Prasad   +6 more
core   +1 more source

Pseudotremia momus Shear

, 2011
Pseudotremia momus Shear P. momus Shear 1972, p. 185. Type locality: Spence Cave, between Saltville and Chatham, Smyth Co., VIRGINIA. Male holotype, female paratype in MCZ.
Shear, William A.
core   +1 more source

Analysis of an alternative topology for steel-concrete-steel sandwich beams incorporating inclined shear connectors

, 2011
This thesis presents a new concept in steel-concrete-steel sandwich construction in which a bi-directional corrugated-strip core is proposed as an alternative inclined shear connector.
Leekitwattana, M., Leekitwattana, Manit
core   +1 more source

Study on the Influence of Freeze–Thaw Cycles on the Shear Performance of the UHPC-NC Interface with Planted Reinforcement

Buildings
Ultra-high-performance concrete (UHPC) has been widely utilised in strengthening and rehabilitating conventional normal concrete (NC) structures due to its exceptional mechanical properties and durability.
Jianjun Liu, Hongping Ye, Kun Yu, Haigang Li, Zepeng Gan, Yujia Wang, Zhimei Jiang, Zhongya Zhang   +7 more
doaj   +1 more source

Research and Analysis of Shear Performance of Inclined Blade Shears Based on ANSYS

Mechanical Engineering Science
Nowadays, enterprise customers have higher and higher requirements for steel plate quality, and the performance research of shearing machine has been widely paid attention to. In this paper, the finite element analysis software ANSYS is used to analyze and verify the key parts of the downcut inclined blade shears.
Meili YU, Guangchen XU
openaire   +1 more source

Thermal Cycle–Microstructure–Property Relationships in Rail Steel Heat‐Affected Zone Simulated by Gleeble

Advanced Engineering Materials, EarlyView.
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo, João Marcos da Silva Nunes, Marcelly Cristiny Nunes de Carvalho, Alex Rojas, Cristie Luis Kugelmeier, Cristhian Ricardo Loayza Loayza, João Carlos Ferreira, Maria Veronica Goncalves Rodrigues, Rute Sayuri Kano, Isaac Araújo Furtado, Jacyara Dalylla da Silva Nunes, Jhonatan Peres de Sousa, Marcos Natan da Silva Lima, Eden Santos Silva, Gedeon Silva Reis, Samuel Filgueiras Rodrigues   +15 more
wiley   +1 more source

Influence of Bolt Arrangement on the Shear Performance of Circumferential Joints of Segments in Super-Large Cross-Section Shield Tunnels

Buildings
To evaluate the shear performance of circumferential joints in super-large cross-section shield tunnels featuring inclined bolts and distributed mortises and tenons, refined numerical models were developed for three distinct configurations: single-bolt ...
Haijun Wang, Wei Qiu, Linjian Su, Shaoyi Yang, Yi Xie, Bohan Wu, Luxiang Wu   +6 more
doaj   +1 more source

Influence of Particle Shape and Size in Copper‐Based Low‐Temperature Metallization Paste for Solar Cells

Advanced Engineering Materials, EarlyView.
Particle morphology controls the balance between printability and electrical connectivity in low‐temperature AgCu/Ag metallization pastes. Flake‐shaped AgCu particles form extended low‐resistance contacts, whereas spherical particles favor processability at high metal loading. Fine Ag particles further tune void filling and conductive‐network formation
O. Mhirsi, M. N. Wengenmeyr, J. Bartsch, B. E. Rapp   +3 more
wiley   +1 more source