Results 61 to 70 of about 1,439 (167)
Surface roughness, hardness, and fatigue-corrosion characteristic of AISI 316L by shot peening
Metalurgija, 2020 The surface of AISI 316L was treated by shot peening at different shot durations. Shot peening variables in this work are shot durations for 0, 4, 10 and 20 minutes, with compressor pressure at 8 kgf/mm2, steel balls with a diameter of 0,6 mm and shot ...
P. T. Iswanto +4 more
doaj
A Study on the Microstructural Evolution of a Low Alloy Steel by Different Shot Peening Treatments
Metals, 2018 Recent studies have shown that severe shot peening can be categorized as a severe plastic deformation surface treatment that is able to strongly modify the microstructure of the surface layer of materials, by both increasing the dislocation density and ...
Juan González +3 more
doaj +1 more source
Enhancing mechanical properties of FSW joints in 6061 aluminum alloy through post-weld shot peening treatment [PDF]
E3S Web of ConferencesThis study investigated the effects of post-weld shot peening treatment on friction stir welded (FSW) joints in 6061 aluminum alloy. It is well known that FSW joints experience softening and a reduction in mechanical properties compared to the base ...
Wartono, Pamuji Didit Setyo
doaj +1 more source
Analysis of the Effects of Aggressive Shot Peening on Fatigue Life of 7075 – T6 Aluminum Alloy
Al-Khawarizmi Engineering Journal, 2012 For many years controlled shot peening was considered as a surface treatment. It is now clear that the performance of control shot peening in terms of fatigue depends on the balance between its beneficial (compressive residual stress and work hardening ...
Khairallah S. Jabur
doaj +2 more sources
STUDY THE EFFECT OF SHOT PEENING RESIDUAL STRESSES ON COMPRESSIVE STRENGTH OF STIFFENED PANEL
Jixie qiangdu, 2020 To determine the effects of shot peening on stiffened panel compressive strength,a typical shot peening residual stress was introduced by ABAQUS subroutine.
ZHANG ZiPeng, LIU Cun, YIN KaiJun
doaj
Jixie chuandongThe shot peening strengthening process can introduce residual compressive stress field on the surface and subsurface of spiral bevel gears to improve their fatigue life.
Liao Xianggui +3 more
doaj
Fenmo yejin jishuThe iron-based parts with different densities were prepared by powder metallurgy, and then were densified by ultrasonic shot peening. The diamond-like carbon (DLC) self-lubricating coatings were deposited on the sintered and shot peening samples with ...
ZHU Yebiao +3 more
doaj +1 more source
Effect of Shot Peening on the Strength and Corrosion Properties of 6082-T651 Aluminium Alloy. [PDF]
Materials (Basel), 2023 Ravnikar D, Šturm R, Žagar S.
europepmc +1 more source
Analysis of Geometric Surface Structure and Surface Layer Microhardness of Ti6Al4V Titanium Alloy after Vibratory Shot Peening. [PDF]
Materials (Basel), 2023 Matuszak J.
europepmc +1 more source